Driver Amplifiers for SAR ADCs, Single-Ended Input Analog-to-Digital Converters Max Throughput (MSPS) Bipolar/ Unipolar Supplies Part Number Driver Amplifiers Signal Frequency 0 kHz to 20 kHz Input Channels Max Input Signal Frequency for Highest ENOB (kHz) Unipolar Unipolar Supply Voltage Supply Voltage (>5 V) (>5 V) Learn more about designing with SAR ADCs and driver amplifiers using Circuits from the Lab® reference circuits: www.analog.com/circuits. CN-0260 Circuit Note, Oversampled SAR ADC with PGA Achieving Greater than 125 dB Dynamic Range: www.analog.com/CN0260 CN-0194 Circuit Note, Galvanically Isolated, 2-Channel, 16-Bit, Simultaneous Sampling, Daisy-Chained Data Acquisition System: www.analog.com/CN0194 CN-0255 Circuit Note, A Complete Single-Supply, 16-Bit, 100 kSPS PulSAR ADC System Dissipates 8 mW: www.analog.com/CN0255 CN-0187 Circuit Note, Crest Factor, Peak, and RMS RF Power Measurement Circuit Optimized for High Speed, Low Power, and Single 3.3 V Supply: www.analog.com/CN0187 CN-0247 Circuit Note, 12-Bit ,1 MSPS SAR ADC and Driver with Total Power Dissipation Less than 5 mW: www.analog.com/CN0247 CN-0165 Circuit Note, Power-Off Protected Data Acquisition Signal Chain Using Fault-Protected CMOS Switches: www.analog.com/CN0165 Other resources: More about ADCs: www.analog.com/ADC More about amplifiers: www.analog.com/amplifiers-linears ADC driver website: www.analog.com/adcdrivers

Driver Amplifiers for SAR ADCs, Differential Input Learn more about designing with SAR ADCs and driver amplifiers using Circuits from the Lab reference circuits: www.analog.com/circuits. 'CN-0237 Circuit Note, Ultrabw Power, 18-Bit, Differential PulSAR ADC Driver www.amlog.com/Cm237 "CN-0105 Circuit Note, Single-Ended-to-Dlfferential High Speed Drive Circuit for 16-BH 10 MSPS AD/626 ADC: www.anahg.com/CN0105 -'.MJ-ul 80 Circuit Note, Pir. :.,■»«:. Low Powe i i - ntialADC DIVI /»/ industrial-Level Signals MW .«;.*»/rom CNOiSi Kll "1::, i.ircuit Note, Crest Factor, Peak and RMS BP Power Measurement...