Road Paver Tracked AFT 350 E/G The machine of this class is ideal for small and medium size job sites. The traction on tracks is suitable for job sites on difficult grounds and assures a very good levelling effect. Despite its compact dimensions the machine is able to pave till 4.5 m of width. Applications layers of final wearing course, binder, tout-venant on: national and municipal roads large squares sport grounds and courtyards building lots and parking areas. Tracked machine with rubber pads; automatic tensioning device system with grease accumulator. Hydrostatic transmission with two variable flow rate pumps which feed two motors with two displacements directly fastened to the planetary gearboxes which operate the tracks. Mounted on each pump, an electronic and proportional control gives a progressive start and stop, keeping the set speed constant. The steering-wheel is electronically controlled, the speed is constant when steering. The hoppers are independently controlled by an electric-hydraulic system. The front pushing rollers move in sequence with the hoppers. Two adjustable seats, left/right, can slide externally. The dashboard is adjustable to the seat position to allow easy operations. Ground controls with anti-vandal guards for the road operator. Hydraulic foldable canopy with rear supports to ensure good visibility. Feeding of material The feeding system of the material is carried out by two independent and reverse chain belt conveyors and augers controlled by paddle microswitches that regulate the flow of material to the screed in order to maintain the most effective distribution of the material in any condition. The height of the auger group is electric-hydraulically adjustable. Screed options Screed with tamper and vibration (FST) with gas or electric heating, automatic lighting and temperature control, ISR system (Screed Assist) with pressure adjustment.

A3 A B C D E F G H I L 1:28 5030 4900 1320 1850 3100 3480 1380 2500 2033 1660 AFT350 AFT350 shaping processes ISO 2768 - cL weldment constructions EN ISO 13920 - BF machining processes ISO 2768 -mK final change first used for: AFT350 This drawing is neither allowed to be copied, replicated, shown or open up to third parties or used by third parties for self-construction or production. Deutz TD2011L04i Air / Oil cooling, Diesel Drawn 23/02/2013 Garramone Checked Page 1 / 1 Doc.Type: IDW Length (transport) Engine Brakes Service brake Parking brake/Emergency Multiple disks negative brake on reduction...