Specifications:
The AMI 1310 angle encoder offers pulse options of 9,000 ppr and 18,000 ppr, with interpolation capabilities ranging from 2 to 50 times. It features a stainless steel shaft with a diameter of 10 mm, capable of handling axial loads up to 10 N and radial loads up to 20 N. The maximum rotating speed is 4,000 rpm, and it operates within a temperature range of 0°C to +80°C. The encoder is designed to withstand vibrations of 10 g (20 to 2,000 Hz) and shocks of 100 g (11 ms), with an ingress protection rating of IP 64 on the shaft.

Electrical Data:
The encoder uses a square wave signal with an LED light source. It supports operating voltages of 5 Volt ± 5%, 10 to 30 Volt, and 5 to 30 Volt, with a maximum current consumption of 100 mA without load. The output frequency is 300 kHz for square wave signals at 5 Volt and 10 to 30 Volt, and 1 MHz with interpolation. It features a 5 Volt Line-Driver and a 10 to 30 Volt push-pull short-circuit proof output, with a current output of 20 mA. The encoder provides two channels, A and B, phase-shifted by 90° electrically, and a zero-pulse of 1 pulse per revolution with lengths of 90°, 180°, or 360° electrically. All signals include inversion.

Compliance and Standards:
The encoder complies with the 2014/30/EU EMV-rules and standards DIN EN 61000-6-2 and DIN EN 61000-6-3.

Contact Information:
AMI Elektronik GmbH & Co. Produktions KG, Benzstr. 30, 82178 Puchheim, Tel. +49 (0) 89 800617-0, Email: [email protected], Website: www.ami-elektronik.de

Note: Specifications are subject to modifications.