Chatillon® TT Series Pneumatic Force Tester Specification Sheet The CHATILLON® TT Series is a pneumatically-operated tester for measuring breaking strength of electrical leads, terminals, connectors, wire wraps, etc. It is ideal for areas where intrinsic safety is required (when used with a mechanical gauge). The TT Tester operates using clean, dry air with a maximum air pressure up to 160 psig (11.2 bar). The TT Tester meets MIL-T-7928 (ASG) requirements for crimped, solderless lugs. The tester may be used for tensile or compression testing. The rapid test speed makes it ideal for production line testing, incoming inspection testing or for the R&D laboratory. The TT Tester features a 6-inch (15 cm) test stroke. Ram speed may be controlled as low as 0.1-inch (2.5 mm) per minute. The TT Tester is available in two models: one with a foot-actuated switch; the other with a hand-actuated switch. Simple to Operate Meets MIL-T-7928 (ASG) Requirements 6-inch Stroke Precise Ram Speed Control to 0.1 in/min Independent Return Speed Automatic Retracting Jaws Mounts to Chatillon DF Series Force Gauges 1 Year Warranty Specifications Load Capacity: Sample Size: Crosshead Speed: Travel: Jaw Opens: Jaw Closes: Load Measurement: Air Motor: For 225 lbf (1 kN): For 550 lbf (2.5 kN): Operating Temperature: Instrument Weight: Shipping Weight: 500 lbf, 2.5 kN Up to 15 inch (380mm) 7/32 OD 6 in/min 6 inches (152mm) 7/32 inch (5.6mm) 1/2 inch (12mm) Chatillon DF Gauges Requires 60 psi (4.2 bar) Requires 125 psi (8.7 bar) 40°F to 110°F 5°C to 45°C 50 lbs (25 kg) 65 lbs (30 kg) Quality Assured. Visit us on the worldwide web: www.chatillon.com Shown: TT Tester Series with optional Chatillon DFE Series digital force gauge.

Ordering TT Series Model Hand Operated Switch Foot Operated Switch Standard Accessories Part No. Foot Pedal (ML3353 only) Shown: ML1797 Foot Pedal Controller. Supplied standard with ML3353. Optional Accessories Part No. Foot Pedal Controller 3/8-16 NC2 Tapped Holes in Bottom of Base for Mounting Base Back Side 8.25” (210mm) Speed Adjustment Screw Measurement & Calibration technologies Americas AMETEK Measurement & Calibration Technologies 8600 Somerset Drive Largo, Florida 33773 United States of America Tel +1-727-536-7831 Tel +1-800-527-9999 Fax +1-727-539-6882 Email [email protected]...