Custom Power Systems
2Pages

Fast Setup California Instruments cabinet systems are carefully designed and manufactured to provide maximum system performance and reduce installation cost. The various ele- ments that make up an integrated high power AC test system are carefully assembled in a high quality 19 inch cabinet. All input and output wiring is properly sized and routed for optimal performance and safety. Conguration problems or wiring mistakes are eliminated when ordering a cabinet based multi-box power system like the 15003iX or a three phase compliance test system like the 30003iX-CTS. This translates into faster setup time and reduced installation hassles upon receipt of your power system. > Completely congured and pre-wired AC test systems > All system units are mounted using rack slides for easy access and removal > Suitably rated input circuit breaker provides system level protection and single shut-o Rack Slides AC power sources can be rather heavy when compared to typical 19 inch test instruments. This makes it more dicult to mount them in a cabinet unless they are properly sup- ported. CI cabinet systems use heavy duty rack slides that can easily handle the weight of the AC source. The use of rack slides over angle brackets allows each unit to be installed and removed easily should there ever be a need to remove or replace an individual unit. Adjustments can be made by simply pulling a unit forward on its slides.Stops prevent any unit from being pulled too far forward. Wiring to the power sources is done with adequate service loops to allow units to remain connected as they are pulled to a forward position. > Sucient Clearence provided for increased airow through system > Clearly labeled AC input and output terminal blocks are provided at the bottom rear of each cabinet for easy access s to allow units to remain connected as the y y y are pu p p p p p p p p lled Single or Multi-chasis Design Many of our higher power solutions involve several products connected in parallel to achieve the required power. Also, some custom configurations feature additional chassis for more sophisticated control, precision power impedance matching, or electronic drop-out switching. Cabinet systems are usually shipped as fully assembled, wired, and tested solutions. > Wide base prevents accidental tipping, even if all units are pulled out on rack slides > Heavy Duty ball-bearing casters allow cabinets to be moved around easily >

Connection of the EUT can be accomplished through an output terminal compression block, also located at the lower rear of the cabinet.Inputs and outputs are clearly marked to mini-mize connection errors. Finally, strain reliefs are provided for both input and output wiring. Cooling > To ensure long-term durability, careful attention is dedicated to proper airow in the cabinet. Sucient clearance is provided on the sides and at the back of the power sources. A rear panel screen protects the user from accidental access to the inside of the cabinet while at the same time allowing sucient...