*mydirectindustry

CMFA-P 2000

1 / 2 PagesView full catalog

CMFA-P 2000

Product catalog summary

Key Benefits:

The CMFA-P2000 functions as both a flue gas O2 analyzer and a premix gas analyzer.
It includes a built-in compressor for sampling flue gas.
Operates effectively in environments with either excess fuel or excess air.
In premix mode, it measures the air/fuel ratio in open-flame applications where direct flue gas measurement is impractical.
Offers superior accuracy compared to direct O2 or combustible measurements in premix gas.

Applications:

Spot sampling in glass melting tanks.
Tuning mix stations on forehearths.
Controlling furnace atmosphere.
Flame treating processes.

Key Markets:

Glass manufacturers.
Glass fiber manufacturers.

Product Description:

The CMFA-P2000 is designed for dual furnace combustion requirements in glass container manufacturing. It uses a platinum zirconium oxide cell to measure excess oxygen in flue gas or premixed combustion samples. The analyzer is portable, with separate analysis and control units, and includes an optional air compressor for sampling low flow premix gases.

Performance Specifications:

Enclosure: Aluminum carrying case.
Operating Range: 100% to 0.1% excess O2 and 0.1% to 50% excess fuel.
Display: Four-line, 20-character vacuum fluorescent display with password protection and diagnostics.
Analog Output: Isolated, linear current output, fully scalable.
Calibration: Supports calibration and verification with data storage.
Power Requirement: 115 VAC or 230 VAC, 50-60 Hz.
Environmental Conditions: Control section: 14°F to 116°F; Sensor section: -5°F to 100°F; Relative humidity: 10% to 90% noncondensing.
Sample Temperature: Flue gas inlet: 0°F to 2000°F; Premix inlet: 32°F to 122°F.
Accuracy: ±2% of measured value or ±0.1% O2; ±5% of measured value or ±0.25% excess fuel.
Response Time: O2: 63% <18 seconds; 90% <22 seconds. Excess fuel: 63% <17 seconds; 90% <63 seconds.
Drift: Less than 0.1% of cell output per month.
Repeatability: ±0.2% of measured value.
Sample/Calibration Gas Flow Rate: 2 SCFH (1 liter/min).
Max. Sample Pressure: 10 PSIG (68.95 kPa).
Dimensions: 10.75” x 18” x 16”.
Weight: 44 lb (19.9 kg).
Compliance: EMC Directive: 2004/108/EC; Low Voltage Directive: UL 3101-1.

Catalog excerpts

AMETEK PROCESS INSTRUMENTS PRODUCT DATA SHEET CMFA-P2000 Portable Premix Gas/Flue Gas Analyzer Accurate, versatile pre-combustion analysis of flue gas The CMFA-P2000 - Combustion mix flue gas analyzer was designed specifically to meet the dual furnace combustion requirements of glass container manufacturing plants. Using a highly reactive bare platinum zirconium oxide (ZrO2) cell, the analyzer is capable of measuring excess oxygen (O2) in post combustion flue gas or excess O2 to excess fuel in premixed combustion samples feeding forehearth zones. The transportable two piece analysis and control arrangement allows separation so that the readout control can be viewed while making remote adjustments of premix and combustion air valves. An optional air compressor for driving the integral air operated aspirator is available for sampling low flow premix gases, and pulling flue gas samples under draft conditions. The Series 2000 microprocessor control unit provides a four-line digital display, analog outputs, alarms, system and sensor diagnostics and software supported calibration. • Two analyzers in one - acts as a flue gas O2 analyzer or a premix gas analyzer • Built-in compressor for pulling flue gas samples into the analyzer • Works in either excess fuel or excess air environments • In premix mode, measures air/fuel ratio in open-flame applications where flue gas measurements are impractical • Provides much better accuracy than directly measuring O2 or combustibles in the premix gas APPLICATIONS • Spot sampling glass melting tanks • Mix station tuning on forehearths • Furnace atmosphere control • Flame treating H key markets • Glass manufacturers • Glass fiber manufacturer To find out more or request a quote visit our website ametekpi.com

Open the catalog to page 1

CMFA-P2000 Portable Premix Gas/ Flue Gas Analyzer SALES, SERVICE & MANUFACTURING WORLDWIDE SALES AND SERVICE LOCATIONS Canada - Alberta 2876 Sunridge Way NE Calgary AB T1Y 7H9 Tel: +1 403 235 8400 Fax: +1 403 248 3550 © 2018, by AMETEK, Inc. All rights reserved. Printed in the U.S.A. F-0158 Rev 7 (0818) One of a family of innovative process analyzer solutions from AMETEK Process PROCESS INSTRUMENTS Instruments. Specifications subject to change without notice. Model CMFA-P2000 Portable Analyzer - F-0158.indd 2

Open the catalog to page 2

CMFA-P 2000

CMFA-P 2000

Catalog excerpts

All AMETEK Process Instruments catalogs and technical brochures