Catalogs >
AMETEK Process Instruments >
910 Hot Wet Multi Gas CEM

910 Hot Wet Multi Gas CEM
2Pages

Catalog excerpts

AMETEK , PROCESS INSTRUMENTS A MEASURES: SO2, NO, NO2, O2, mass flow PRODUCT DATA SHEET 910 Hot/Wet Multi-Gas CEMSpecifically configured for monitoring stack emissions of multiple pollutants on a mass rate basis The 910 is a multi-component analyzer capable of measuring up to five different gases simultaneously. It is a complete system with a sample extraction and transport system designed for maintaining sample integrity. The 910 performs analyses that typically require two or more separate analyzers, making it an economical alternative when several gases must be monitored. It performs all necessary sample gas and calibration gas flow management, and probe and sample line temperature control. The 910 is a full-function continuous emissions monitoring (CEM) system, which requires the addition of only a sample probe and sample line to be fully operational. Ultraviolet (UV) technology Using high-resolution UV technology in a dual-beam, multiple-wavelength configuration, the 910 has a resolution of better than 0.02 nm. A six-position filter wheel enables one reference and five measure wavelengths. The dual-beam configuration, combined with the reference measurement, ensures low noise performance with minimal baseline and span drift. UV measurements do not suffer from water (H2O) and carbon dioxide (CO2) interference as these species are transparent in the UV. This greatly simplifies sample handling. Fully extractive, heated wet-basis analyzer The sample cell and all components in contact with the sample are heated above the dew points of all gases in the sample stream. This results in a simpler and more accurate calculation of gas concentrations, requiring no corrections for condensed and dissolved components. It also results in a simpler analytical system, as there is no need for sample drying or conditioning. Hkey benefits • Multi-component gas analysis (up to five species) • Multi-range sulfur dioxide (SO2) measurement • Independent nitric oxide (NO) and nitrogen dioxide (NO2) measurement • No H2O or CO2 interference • Automated zero and span gas calibration • Four-zone temperature control-sample line, probe, sample conditioning unit and oven • Provides serial interface with plant distributed control system (DCS) • Incorporates flow measurement for emission rate calculations El APPLICATIONS • Sulfur plants • Smelters • Coal, oil, and gas-fired power plants • Industrial boilers PH KEY MARKETS • Sulfur recovery • Nitric acid plants • NOx scrubbers To find out more or request a quote visit our website ametekpi.com PRO-035_Model 910 Hot/Wet Multi-Gas - F-0176 _V4.indd 1 04/10/2018 16

Open the catalog to page 1

PRODUCT DATA SHEETPERFORMANCE SPECIFICATIONS Methodology SALES, SERVICE & MANUFACTURING WORLDWIDE SALES AND SERVICE LOCATIONS Canada - Alberta 2876 Sunridge Way NE Calgary AB T1Y 7H9 Tel: +1 403 235 8400 Fax: +1 403 248 3550 AMETEK* PROCESS INSTRUMENTS © 2018, by AMETEK, Inc. All rights reserved. Printed in the U.S.A. F-0176 Rev 8 (0818) One of a family of innovative process analyzer solutions from AMETEK Process Instruments. Specifications subject to change without notice.

Open the catalog to page 2

910 Hot Wet Multi Gas CEM 2Pages

Catalog excerpts

All AMETEK Process Instruments catalogs and technical brochures

910 Hot Wet Multi Gas CEM
2Pages