Quick Reference Power On fTareft-lbsnimHg mmfkO nnnu.uu Zero_ _ OOO 1 ^ (Se‘UPtil OP > MOkPa! 1.4kg/cm2 Backlight AMETEK

Note: Pressing the enter button always returns the gauge to operating mode. If you want to set multiple Display Functions, press the setup button to navigate from one Display Function to the next, then press the enter button when you are done. 1 Access Setup 2 View Setup options 3 Select an optionGauge Setup Map Pressure Units Maximum, Minimum, or Averaging All units are not available with every pressure range. * HpQ icons and temperature settings will only display on HyQ enabled units.

Gauge Setup Map continued This menu can be accessed only when the gauge is off. — Lt: 15 (light stays on for 15 seconds) — Lt: 60 (light stays on for 60 seconds) I— Lt: On (light does not turn off automatically) To Clear Peaks or Line Pressure Ultra Low Power Mode The Ml checks the internal calibration every time it's turned on. Contact factory for further instructions. The M1 has tried to display a number too large for the display due to electrical malfunction or numerical error. Contact factory for further instructions. The M1 pressure sensor is exhibiting behavior out of normal operating condition....

© 2013 Crystal Engineering Corporation 708 Fiero Lane, Suite 9, San Luis Obispo, California 93401-8701 TEST & CALIBRATION INSTRUMENTS