CPF Brochure (D)
4Pages

{{requestButtons}}

Catalog excerpts

CPF Brochure (D) - 1

Always Seals Always Safe TEST & CALIBRATION INSTRUMENTS

Open the catalog to page 1
CPF Brochure (D) - 2

Improving on an Industry Standard Now, 2 Ways to Seal: With Your Fingers, or with a Wrench CPF to CPF O-Ring Seal CPF to non-CPF Metal Seal ¼" medium pressure cone-type fittings lack an o-ring. Use a wrench to create a seal. CPF Male to non-CPF Female Contact Points Contact Points Super-Flexible, Lightweight Calibration Hose Purpose Designed for Calibration and Testing Inside hose diameter is only 0.08" [2 mm] Manufactured by the experts in pressure measurement. Minimum 1" (2.5 cm) Bend Radius — even under pressure. Safe • Made to Last Small inner hose diameter reduces pumping effort and...

Open the catalog to page 2
CPF Brochure (D) - 3

4 Ways CPF Fittings Keep You Safer Avoid Accidents CPF Fittings and Hoses* are machined in High-Strength 316 Stainless Steel to operate with a 4:1 Safety Factor at 10,000 PSI/700 bar/70 MPa. The Self-Venting Weep Hole alerts you, by leaking gas or test fluid, BEFORE you fully disconnect from a pressurized system. You’ll never make this mistake again. No Leaks–Ever Should your O-ring leak in the field (due to chemicals or wear), simply pull it out and replace it, or use a wrench to create a metal-metal seal. Either way, you keep working safely. My test had been running for the last 20...

Open the catalog to page 3
CPF Brochure (D) - 4

Crystal Engineering Corporation 708 Fiero Lane, Suite 9, San Luis Obispo, CA 93401, USA Telephone: +1 805.595.5477 | Fax: +1 805.595.5466 Dear Fitting User, Several years ago we were working with a key customer at a tradeshow when the tting we were using came apart, under pressure, in the middle of the test. It was embarrassing! And dangerous. But when we walked over to the faulty tting manufacturer’s booth, they were not surprised or shocked at all. Instead, they laughed! Wrong answer. That following Monday, we made a decision. After a year and a half of painstaking design and careful...

Open the catalog to page 4

All Ametek Calibration catalogs and technical brochures

  1. PTC series

    14 Pages

  2. RTC series

    15 Pages

  3. PK II

    3 Pages

  4. ATMi

    7 Pages

  5. HPC50

    6 Pages

  6. CrystalCalHP

    7 Pages

  7. m1M Manual

    4 Pages

  8. 30 Series

    4 Pages

  9. FastCalXP

    9 Pages