1. Catalogs
  2. Ametek Calibration
  3. 24 VDC Power Supply Manual

24 VDC Power Supply Manual

24 VDC Power Supply Manual

24 VDC Power Supply Manual

Product catalog summary
Introduction
The 24VDC Loop Power Supply (24VDCPS) is a portable, battery-powered device ideal for locations without available power. It provides a low noise regulated output suitable for smart transmitters and features automatic power-off to conserve battery life. The device includes short circuit protection and three LEDs to indicate power, low battery, and fault status. A protective boot and two AA batteries are included.

Operation
To operate, connect the loop and press the On key to enable output voltage. The device lacks an Off switch; it powers off automatically when the loop is disconnected. If reconnected within 30 seconds, it powers on automatically.

Batteries
The 24VDCPS uses two AA batteries, with Lithium, Alkaline, or NiMH recommended. Rechargeable batteries should be removed when the Low Battery LED illuminates to prevent damage. Non-rechargeable batteries can be used until the Red Fault LED lights up. Lithium batteries are preferred for cold weather. Battery replacement involves removing the protective boot and sliding off the battery cover, ensuring correct polarity.

Electrical Specifications
Output Voltage: 24 VDC +/- 2%
Output Voltage Ripple: < 14 mV rms
Load Regulation: 1%
Rated Output Current: 25 mA
Short Circuit Protection: Continuous
Connections: 4mm banana jacks
Operating Temperature: -20 to 50°C (-4 to 122°F)
Storage Temperature: -40 to 75°C (-40 to 167°F)
Operating Humidity: 95% Relative, non-condensing
Power Supply: 2 x AA batteries (alkaline 1.5 V included)

Mechanical Specifications
Dimensions: 4.8" x 3.1" x 1.2"
Weight: 200 g (0.44 lbs) including alkaline batteries

Enclosure
Rating: IP40
Housing: ABS
Protective Boot: Silicone Rubber

Certifications
The 24VDCPS complies with international standards and the Electromagnetic Compatibility Directive. It meets EN 55011 and EN 61326 standards for emissions and immunity.

Ordering Information
P/N 24VDCPS KIT includes the power supply and test lead set.
P/N 24VDCPS is the power supply only.
P/N 1351 Test Lead Kit includes banana plug leads with alligator clip and hook tip probes.

Warranty
The product is warranted against defects for one year from purchase. This warranty excludes batteries and damage from misuse or abnormal conditions. Repair or replacement is free unless misuse is determined.

Contact Information
Phone: (805) 595-5477
Toll-Free: (800) 444-1850
Email: [email protected]
Web: crystalengineering.net
See more

Catalog excerpts

24 VDC Power Supply Manual-1

24VDC Loop Operation Manua Power Supply

 Open the catalog to page 1
24 VDC Power Supply Manual-2

24VDC Loop Power Supply Operation Manual   1 INTRODUCTION The 24VDC Loop Power Supply (24VDCPS) is a portable, battery-powered, loop power supply and is ideal for sites where power is unavailable. The low noise regulated output is suitable for use with smart transmitters. Power is automatically turned off when load is removed, preserving battery life. Outputs feature short circuit protection. Three LEDs indicate power, low battery, and fault status. A protective boot and two AA batteries are included. QUICKSTART/OPERATION DIAGRAM Output Terminals: 24 VDC output. Observe correct polarity. On when...

 Open the catalog to page 2
24 VDC Power Supply Manual-3

24VDC Loop Power Supply Operation Manual   2 BATTERIES The 24VDCPS uses 2 AA batteries. Recommended batteries are Lithium (non-rechargeable), Alkaline, or NiMH (rechargeable). To avoid damage by over-dis- charging, rechargeable batteries should be removed when the Low Battery LED () illuminates. Non-Rechargeable batteries may continue to be used until the Red Fault LED () illuminates, at which time the output voltage will have fallen below 24 V. Lithium batteries are recommended for best performance in cold weather operations. Typical Battery Life (Conditions: 12 mA loop current, 23° C) Battery...

 Open the catalog to page 3
24 VDC Power Supply Manual-4

24VDC Loop Power Supply Operation Manual   3 ELECTRICAL SPECIFICATIONS Output Voltage 24 VDC +/- 2% Output Voltage Ripple < 14 mV rms Load Regulation 1% Rated Output Current 25 mA Short Circuit Protection Continuous Connections 4mm banana jacks Operating Temperature -20 to 50°C (-4 to 122°F) Storage Temperature -40 to 75°C (-40 to 167°F) Operating Humidity 95% Relative, non-condensing Power Supply 2 x AA batteries (alkaline 1.5 V included) MECHANICAL SPECIFICATIONS Overall Dimensions 4.8" x 3.1" x 1.2" Weight 200 g (0.44 lbs) including alkaline batteries ENCLOSURE Rating IP40 Housing ABS Protective...

 Open the catalog to page 4
24 VDC Power Supply Manual-5

24VDC Loop Power Supply Operation Manual   4 DECLARATION OF CONFORMITY According to ISO/IEC 17050-1:2010 Manufacturer’s Name: Crystal Engineering Corporation An AMETEK Inc. company Manufacturer’s Address: 708 Fiero Lane, Suite 9 San Luis Obispo, CA 93401 USA Declares under sole responsibility that the product as originally delivered Product Name: Model Number: 24VDC Loop Power Supply Series 24VDCPS Complies with the essential requirements of the following applicable European Directives, and carries the CE marking accordingly: EMC Directive 2004/108/EC Standard EN 55011:2007 EHSR EN 55011:2009/A1:2010...

 Open the catalog to page 5
24 VDC Power Supply Manual-6

24VDC Loop Power Supply Operation Manual   5 CONTACT US Phone (805) 595-5477 Toll-Free (800) 444‑1850 Fax (805) 595-5466 Email [email protected] Web crystalengineering.net TRADEMARKS This manual contains the following third-party trademarks, both registered and unregistered. All marks are the property of their respective companies. Rayovac® and Maximum Plus™ . . . . . . . . . . . . . . . . . Rayovac Corporation Duracell®. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Duracell Inc. Corporation Energizer® and Eveready. . . . . . . . . . . . . . . . . . . . . . . Eveready...

 Open the catalog to page 6
24 VDC Power Supply Manual-7

© 2014 Crystal Engineering Corporation 708 Fiero Lane, Suite 9, San Luis Obispo, California 93401-8701 TEST & CALIBRATION INSTRUMENTS

 Open the catalog to page 7

All Ametek Calibration catalogs and technical brochures

  1. FastCalXP

    9  Pages

*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.