Benson ULTRA
8Pages

{{requestButtons}}

Catalog excerpts

Benson ULTRA - 2

Low NOx High Efficiency Condensing Unit Heaters The units exceed the requirements of current Building Regulations L2, with thermal efficiencies up to 109% to provide exceptional levels of seasonal efficiency. Also the extremely low NOx modulating pre-mix burner enables BREEAM points to be claimed (when applicable). These 4th generation units utilise tubular primary heat exchanger and a secondary condensing heat exchanger with an aerodynamic profile and 4-pass flue gas circuit. Model Range The ULTRA condensing units consisting of five models is available with heat outputs ranging from 25kW...

Open the catalog to page 2
Benson ULTRA - 3

Advanced Heat Exchanger Technology Optimum Economy and Fuel Savings As the flue gases pass through the secondary heat exchanger, the extra surface area cools the flue gases below 45°C causing the water vapour to condense and release its latent heat. In times of rapidly increasing energy costs, reducing energy consumption makes sense both financially and environmentally since this also significantly reduces CO2 emissions. This heat, which would normally be lost to the atmosphere via the flue, is instead transferred into the building hence less fuel is used to achieve the same heat output....

Open the catalog to page 3
Benson ULTRA - 4

Primary Heat Exchanger Manufactured from high quality corrosion resistant steel, the entirely new primary heat exchanger reduces thermal stress for enhanced life expectancy. This tubular heat exchanger is welded to the burner box using the newest robotic welding technology to form a highly resistant and durable assembly. Secondary Heat Exchanger The secondary heat exchanger is manufactured using high quality corrosion resistant materials, the non-welded design of the heat exchanger reduces thermal stress for enhanced life expectancy. This heat exchanger constitutes the second part of the...

Open the catalog to page 4
Benson ULTRA - 5

Air Distribution Flue spigot supplied as option at point of order. A high capacity axial flow fan is fitted to all units for improved air throws and reduced stratification. The fan operation is controlled by an integral controller which delays the fan start up until the heat exchanger has reached operating temperature and continues to run the fan after the burner has switched off until all useful heat has been dissipated. An optional economy thermostat may be fitted to heaters installed at high level to recirculate warm air down to working level when the burner is switched off. Horizontal...

Open the catalog to page 5
Benson ULTRA - 6

Enhanced Reliability and Safety Units may be suspended or alternatively mounted on a suitable non-combustible support. Four integral suspension points complete with an M10 female thread are provided to each heater. The balanced flue terminal provides both the combustion air inlet and flue outlet from a single building penetration. The terminals are ordered separately from the heaters to suit either a wall or roof outlet. Additional flue and combustion air pipes may be added, up to a maximum of nine metres of flue pipe, plus nine metres of combustion air pipe. (This reduces by 1.5 metres for...

Open the catalog to page 6
Benson ULTRA - 7

Low NOx High Efficiency Condensing Unit Heaters Optional SmartCom MZ panel allows up to 16 panels to be linked for centralised control Optimised Control To complement the high efficiency ULTRA units a versatile range of SmartCom control panels are available > Self adapting optimum start and stop > Simple user friendly programming > Individual seven day programming > Day, night and frost (5"C) temperature settings > Three on/off periods per day > Easy set overtime and holiday periods Remote burner reset facility > Password protection to prevent unauthorised adjustment > Hours run and...

Open the catalog to page 7
Benson ULTRA - 8

ULTRA Dimensions *Heaters may be base mounted directly onto non-combustible supports adequately sized to support the unit weight Plan View 3. External Gas Connection 4. Electrical connections 5. Condensate drain dia 32mm female NORTEKGLOBAL HVAC NORTEK GLOBAL HVAC (UK) LTD Fens Pool Avenue Brierley Hill West Midlands DY5 1QA United Kingdom Tel: 01384 489 700 Fax: 01384 489 707 bensonsales@nortek.com www.bensonheating.co.uk Document reference number: GB/BEN/ULT/004/0416 Registered in England No. 01390934. Registered office: 10 Norwich Street, London, EC4A 1BD. Nortek Global HVAC is a...

Open the catalog to page 8

All AmbiRad Ltd catalogs and technical brochures

  1. Airbloc AC

    24 Pages

  2. AmbiRad RV

    4 Pages

  3. Benson DS

    4 Pages

  4. Benson OUH

    4 Pages

  5. Benson UESA

    8 Pages

  6. Benson UDSA

    8 Pages