Benson External Cabinet Heaters
8Pages

External Cabinet Heaters All units are IP44 rated purpose designed for external installation and are available in both vertical and horizontal configuration. All heaters are CE certified in accordance with EN1020. Model Range Vertical and horizontal Cabinet heaters are available as either gas or oil fired models. >> Gas fired cabinet heaters are suitable for use with Natural Gas (G20), most units can also be specified for Propane (G31) Oil fired cabinet heaters are suitable for use with Class D gas oil (35 sec), most units can also be specified for Kerosene (28 sec oil) Vertical...

Low ambient units for installations where external temperatures are below -5oC High/low or fully modulating burners Fresh air inlet louvres Manual or motorised inlet dampers Up-rated fan motor for increased static pressure External cabinet heaters are designed specifically for outdoor location and as such obtain necessary combustion air via the inlet louvres in the control compartment door. Where heaters are installed in very low ambient temperatures it may be desirable to duct the combustion air from the heated building to the heater via a combustion air connection. Where ducted combustion...

Optimised Control Benson external cabinet heaters are supplied ready for fully automatic operation and are complete with both safety and comfort controls. Each heater is fitted with a safety overheat thermostat and supplied with a time and temperature control system. As standard, heaters are supplied with a remote SmartCom, an optimised control that includes a secure entry code facility, an optimised digital time switch with override facility, electronic day thermostat, and frost protection sensor. The control is supplied loose. Inter-connecting wiring between heater and remote control is...

1. Gas lines must be adequately sized and reduced at appliance as required. 2. Standard external cabinets are designed to take combustion air directly from external source, however combustion air may be ducted from the heated space for installations where external ambients are very low. This option must be specified at time of order. 3. Noise levels measured at 5 metres from appliance.

External Vertical Cabinet Heaters EVD Side return air spigot shown is on right hand side but can be specified for left hand side. The side required for the return air spigot must be specified at time of order. Return air spigot sited on the rear panel is available on certain models.

External Horizontal Cabinet Heaters EHD L Centres Duct Outlet Heater shown is with airflow right to left, units may also be specified for airflow left to right. Airflow direction required must be specified at time of order. Optional locations for return air spigots are detailed on rear of brochure.

NORTEK GLOBAL HVAC NORTEK GLOBAL HVAC (UK) LTD Fens Pool Avenue Brierley Hill West Midlands DY5 1QA United Kingdom Tel: 01384 489 700 Fax: 01384 489 707 bensonsales@nortek.com www.bensonheating.co.uk Registered in England No. 01390934. Registered office: 10 Norwich Street, London, EC4A 1BD. Nortek Global HVAC is a registered trademark of Nortek Global HVAC Limited. Because of continuous product innovation, Nortek Global HVAC reserves the right to change product specification without due notice.