Benson Cabinet Heaters
8Pages

Cabinet Heaters

Cabinet Heaters Model Range Two stage burner control for gas & oil on certain models Modulating burner control for gas on certain models Supply & recirculation air inlet spigots Supply & recirculation dampers Two stage or modulating damper acutators Burner combustion air adaptors Stainless steel tubular heat exchanger Up-rated fan motor for increased static pressure Gas fired cabinet heaters are suitable for use with Natural Gas (G20), most units can also be specified for Propane (G31) Oil fired cabinet heaters are suitable for use with Class D gas oil (35 sec), most units can also be...

Cabinet heaters 1 Throw is dependent on building height, room temperature and nozzle settings. 2 Gas/oil lines must be adequately sized and reduced at appliance as required 3 Noise levels measured at 5 metres from appliance. Air Distribution Centrifugal fan(s) circulate large air volumes Free blowing heaters are fitted with long evenly across the full heat exchanger throw discharge nozzles complete with surface for enhanced life expectancy. Fans on horizontal louvres and can be rotated models 30 to 85 are direct drive with a single through 360o. Models 85-375 are supplied phase...

Cabinet heaters Vertical Heaters VN/VD Side View Front View 1. Heaters with 3 or 4 nozzles are supplied with extended head on the rear nozzle(s). For applications with restricted headroom, units may be specified with all nozzles at standard height.

Cabinet heaters Air Discharge and Inlet Details VN/VD Duct outlet spigot Return Air Spigots and Filters VN/VD Installation Dimensions Filter cassettes can be withdrawn from either side, ensure adequate clearance for withdrawal i.e. full width of filter box.

Horizontal Heaters HN/HD C Note: Units may be specified for airflow right to left which is the standard configuration as shown. Alternatively units can be specified for airflow left to right. Plan View Unit length Unit height Unit width

Front View BENSON Cabinet heaters

Top or bottom inlet spigot HN/HD Rear inlet spigot HN/HD Side inlet spigot RN/RD Rear inlet spigot RN/RD Installation Dimensions Document reference number: GB/BEN/CAB/001/0416 1 Top clearance applies to units with side air inlet. For units with top air inlet allow 1000mm NORTEK GLOBAL HVAC NORTEK GLOBAL HVAC (UK) LTD Fens Pool Avenue Brierley Hill West Midlands DY5 1QA United Kingdom Tel: 01384 489 700 Fax: 01384 489 707 bensonsales@nortek.com www.bensonheating.co.uk Registered in England No. 01390934. Registered office: 10 Norwich Street, London, EC4A 1BD. Nortek Global HVAC is a...