The cables are made of PL), class 6, foreseen for cable-bearing chains, 2 mt standard length, copper square section according rated current. Rotor / housing alignment (P) has to be executed within +/- 0.1 mm. Optionally, we can supply a mounting tool for achieving that alignment in case of assembly without possibility of accurate alignment. Thermal devices cable consists of 2 shielded pairs 2x2x0.25mm2 section, 7 mm max external diameter. (De) represents: 1 - The maximum diameter passing inside the housing. 2- The minimum diameter necessary for rotor assembly. (Pmax) diameter for pieces in contact with the rotor must never be exceeded. Tapped holes on each side of rotor and housing are angularly aligned. Cable positioning (AF) is theoretical. Leave a free room with a +/-10 arc degrees tolerance around that position, on a 50 mm height from the housing side, for avoiding to stress the cables Do not tighten, twist or bend the power cable on the first 50 mm from motor side. Clamp the cable after those 50 mm. When designing the assembly, take care to insure a perfect contact between housing and user's bore for avoiding thermal problems. For housing mounting, use either external centering diameter (B) or internal centering diameters (A). For execution tolerances (perpendicularity, concentricity...), please consult us. Fluid input and output pipes have to be placed at the opposite of wire outputs on the same axial plane. O-ring grooves designed for 3 mm diameter o-rings. A full integration handbook can be supplied to our customers upon request For further information or specific request about our motors, feel free to contact us.