Catalogs >
Alpha Moisture Systems Ltd >
Wall mounted custom made dew point sampling systems

Wall mounted custom made dew point sampling systems
2Pages

Catalog excerpts

Wall mounted custom made dew point sampling systems - 1

EXAMPLE CUSTOM-COMPACT DEWPOINT SAMPLING SYSTEMS Simplest solution to measure moisture content in a continuous gas or air ﬂow The AMSS Wall Mounted Custom-Compact Sample System Range are engineered solutions for extracting and analysing a representative sample of the process gas or air, which is then either vented to atmosphere or returned to the process. The wall mounted sampling systems range have been specifically designed to condition pressurised gas or air samples up to 200barg maximum ready to measure the moisture levels from a constant and consistent flow. Simply connect to a power source and sample gas, regulate the pressure and flow through the instrument for rapid/accurate dewpoint measurements. The AMSS Custom Compact Sampling Systems are made to order to exact customer requirements and will need little or no maintenance. AMT Aluminium Oxide Dewpoint Transmitter, 2 wire connection, 4-20mA. Ranges available between -120°C to +20°C (-84°F to +68°F) dewpoint PDT Polymer Sensor Dewpoint Transmitter, 2 wire connection, 420mA. Ranges available between -60°C to +50°C (-76°F to +122°F) dewpoint A typical basic AMSS Custom-Compact Sample System can consist of the following: • 4-20mA Display • Dewpoint Transmitter (AMT with Automatic Calibration or a PDT Polymer Sensor) • All Pipework and Fittings in high quality Stainless Steel • Sealed Connection Glands • 316 Stainless Steel Sample Cell Lockable Door Closure Options on Polycarbonate and Stainless Steel Enclosures Pressure Regulator Isolation Valves Inline Filter Unit (coalescing or non-coalescing) Flow Meter (Up to 10 litres per minute) Rugged Polycarbonate Enclosure with clear or opaque lockable door. Door seal to IP67 (NEMA 6), or all high grade stainless steel. Clear Door Options © Alpha Moisture Systems Ltd. High Grade all Stainless Ste

Open the catalog to page 1

Wall mounted custom made dew point sampling systems - 2

Alpha Moisture Systems AMSS Custom-Compact Sample Systems Specifications for DS1200-AMT Dewpoint Hygrometer Arrangement Example DS1200 DISPLAY INDICATOR ENCLOSURE: 1/8 DIN panel mounting ABS case DISPLAY: 4 digit, 14 segment LED indicator. Red characters 13.8mm high. Factory set to display in °C, °F, ppm(v), ppb(v), g/m3 or lbs/MMSCF SUPPLY VOLTAGE: Universal 22Vac - 253Vac 50/60Hz & 20Vdc - 300Vdc 150mA to 15mA POWER CONSUMPTION: 3.5W Maximum OUTPUT SIGNAL: Linear 4 to 20mA, fully isolated. Maximum load 800Ω / 16Vdc ISOLATION: Voltage Test / Operation - 2.3kVac / 250Vac ALARM RELAYS: 2...

Open the catalog to page 2