ky The Standard Duty Pump SolidC Centrifugal Pump Applications The SolidC pump is designed for standard duty applications, like pumping CIP (Cleaning In Place) solutions, utilities, water (processing, heating, cooling), washing machines, simple transport duty within working range. SolidC is suited for use in the food, dairy, beverage, personal care, pharmaceutical, light chemical and water industries. Standard design The SolidC pump is designed for CIP with emphasis on large internal radii and cleanable seals. SolidC has a stainless steel shroud for protection of the motor, and the complete unit is supported on four adjustable legs. Shaft seals The SolidC pump is equipped with either an external single or a flushed shaft seal. Both have stationary seal rings in acid-resistant steel AISI 329 with sealing surface in silicon carbide and rotating seal rings in carbon. The secondary seal of the flushed seal is a long lasting lip seal. . TECHNICAL DATA OPERATING DATA Materials Product wetted steel parts: . . . . . . . . W. 1.4404 (316L). Other steel parts: . . . . . . . . . . . . . . Stainless steel Finish: . . . . . . . . . . . . . . . . . . . . . Blasted (standard) 3A polishing (Ra 0.8). Product wetted seals: . . . . . . . . . . . EPDM (acc. to FDA). Pressure Max. inlet pressure: . . . . . . . . . . . . . 400 kPa (4 bar). Temperature Temperature range: . . . . . . . . . . . . . -10°C to +120°C (EPDM). Flushed shaft seal (FSS): Water pressure inlet: . . . . . . . . . . . . max. 100 kpa (1 bar). Water consumption: . . . . . . . . . . . . 0.25 -0.5 l/min. Connections for FSS: R 1/8" (BSP) external thread. Motor Foot-flanged motor according to the IEC metric standard (EFF II), 2 poles = 3000/3600 rpm. at 50/60 Hz, IP 55 (with drain hole with labyrinth plug), insulation class F. Motor sizes 50 Hz: . . . . . . . . . . . . . . . . . . . . . 1.1 - 22 kW 60 Hz: . . . . . . . . . . . . . . . . . . . . . 1.3 - 25 kW NOTE! When used with frequency converter the 22 kW motor only has 20 kW effect. Warranty Extended 3-years warranty on the SolidC Centrifugal Pump range. The warranty covers all non wear parts on the condition that genuine Alfa Laval Spare Parts are used.

A. Impeller with reduced diameter. B. Motor for other voltage and/or frequency. D. Flushed shaft seal. E. Product wetted seals of Nitrile (NBR), Fluorinated rubber (FPM) F. Rotating seal ring material in Silicon Carbide. Please state the following when ordering: - Pump size. - Impeller diameter. - Motor size. - Flow, pressure and temperature. - Density and viscosity of the product. For further details, see also ESE00797. Alfa Laval reserves the right to change specifications without prior notification. ALFA LAVAL is a trademark registered and owned by Alfa Laval ESE00265EN 1306 Corporate AB....