FD16M 16 Channels Modular Universal I/O Module 16 Universal I/O DIN-rail mounting Modular inputs outputs Modbus RTU Connections and Measurements It can be used as Remote I / O under PLC. 16 pieces modular PORT by user can be adjusted according to your requirements. Allows you to use 5 different I / O Modules o o o o o Digital Input (dry contact) – 2 input ports in a single module 0-10V Analog output 0-10V Analog input PT1000 input Digital (Relay) output Communicates with MODBUS RTU protocol via 1 RS-485 connection 2 RS-485 ports on the device for easy operation. The status of all ports is indicated by communication signal and electric LED

General : 8 Bit processor, 14 Bit A/D converter Communication Protocol: Operating Temperature : Operating Humidity : Storage Temperature : Storage Humidity : Device Size : Package size : 16 Pieces Modular Port(5 different I/O modul connections) MODBUS RTU (Slave) 35mm DIN Rail or Wall Mounting Screw Terminal Block Digital Input 1. One module has 2 pieces digital inputs. The status of the input is s een on the LEDs A and B of the port to which it is connected 1. 10V 14Bit read with precision 2. 0-20mA can be read with 5000 resistor to be connected to related port 2. Sensor information is read...

I/O MODULE MONTAGE . The I / O Modules used in the product must be installed under the control card as shown in the drawing below. After ensuring that the I / O modules and the control card are correctly installed, the device cover must be closed. When all the cards are installed correctly, the cover of the device fits seamlessly. Electrical connection should not be made when the appliance door is open. The cards that are attached to the ports are shown for visual purposes.

Modbus Address: FD16M The Deep-Switches on the device are used to supply the Modbus address. Up to 255 addresses can be given. Each deep-switch indicates a number in binary number sequence Modbus Speed: The FD16M Module communicates via the RS485 serial port in the Modbus RTU protocol. The performance specifications are nominal and conform to acceptable industry standard. For application at conditions beyond these specifications, consult the AID Controls office. AID Controls shall not be liable for damages resulting from misapplication or misuse of its products.