Technical Data Trigger input ZA1006ET Trigger variants can be programmed ZA1006EK2 For external zero-potential contact (not electrically isolated) and for external voltage 4 to 30 VDC (optocoupler), trigger variants can be programmed Current consumption approx. 3 mA Cable length 1.5 meters ALMEMO® trigger cable, V6, with 1 key ZA1006ET ALMEMO® trigger cable, V6, with 2 trigger inputs for external contacts or voltages, with clamp connector ZA1006EK2 Trigger input For external zero-potential contact (not electrically isolated) or for external voltage 4 to 30 VDC (optocoupler) Trigger variants - can be programmed (V6 only) Relay Normally open contact (semiconductor relay) Can also be programmed as inverted (V6 only) Load capacity: 11/2025 • We reserve the right to make technical changes. Current consumption approx. 3 mA Cable length 1.5 meters Connection Clamp connector Variants ALMEMO® trigger / relay cable, V6, with 2 trigger inputs (programmable trigger variant) for external voltages and 2 normally open contacts ALMEMO® trigger / relay cable, V6, with 2 trigger inputs (programmable trigger variant) for external zero-potential contacts and 2 normally open contacts

Relay cable, V6, type ZA 1006 GK_ Relay Normally open (semiconductor relay) Can also be programmed as inverted (V6 only) Load capacity 50 VDC, 0.5 A, 1 ohm Current consumption approx. 3 mA Cable length 1.5 meters Connection Banana plug Control input for optocoupler output or switching contact R <10 kW Output Electrical safety socket, mechanical relay, load capacity 230 V, 6 A Switching status OFF idle; ON alarm 01/2026 • We reserve the right to make technical changes. ALMEMO® relay cable, V6, with 1 normally open contact Order no. Variants Order no. Relay adapter for switching mains supplied...

• The analog signal is controlled internally by the measured value of a measuring channel, arbitrarily scalable. • Respectively, the analog signal is controlled externally via the device interface with the WinControl software. ! Only suitable for the following device types: 104, 710, 809 devices manufactured from 2020 onwards (for older devices, a firmware update is necessary). Output signal: via clamping connector, galvanically isolated (common mass) Accuracy: 0.1 % of measured value Temperature drift: 10 ppm/K Power supply: 12 V via ALMEMO® plug the sensor voltage 12 V is set on the ALMEMO®...