Tensiometer-english
1 /1Page

Tensiometer-english

Tensiometer-english
1 /1Page

Catalog excerpts

Tensiometer-english-1

Ceramic cell: Overall length: Insertion depth: • Measurement of soil moisture through the identification of suction pressure. The suction pressure is the force with which water is being held in the soil or is available for absorption. This is the force that must be produced by the plant roots in order for water to be absorbed. • The porous, clay tip of the tensiometer transfers water from within to the drier outer surroundings by means of capillarity, thereby, creating a sub-pressure within the sealed tensiometer tube. This sub-pressure is a measure of the moisture level and can be determined as a value or used directly to activate an electrical switch. The customary unit of measurement is hPa. • However, a tensiometer also functions in dry air as long as evaporation can take place over the porous, clay chamber. Therefore, moisture levels can be measured even in coarsegrained or very loose substrate. • Suction pressure measurements are largely independent of the salt concentration of the substrate or soil. Cylindrical, with tip, 0 20 x 65 mm approx. 340 mm typical 250 mm Typical Suction Pressure at Peat Substrates 30 - 40 hPa very moist 50 - 120 hPa moist 150 - 200 hPa dried >200 hPa dry Ceramic cell: Cylindrical, with tip, 0 15 x 40 lmn Overall length: approx. 160 mm Insertion depth: typical 70 mm Typical Suction Pressure at Open fields (intermediate grade soil) saturated wet to moist start drying Irrigation Sensor completely porous for measuring in thin layers of substrate. Moisture tension meter, electronics Sink deep: approx. 30 - 60 mm 11/2025 • We reserve the right to make technical changes. Measure range: Output: Power supply: Cable: Technical Data Measurement of soil moisture through the identification of suction pressure. 0 to -1000 hPa relative (negative pressure) 0.3 to 3.0 V Sensor with cable, length = 5 m, with ALMEMO® connector Tensiometer electronics for screwing onto the tensiometer with cable and ALMEMO® connector FDA602TM3 Standard model for use on capillary matting, for moist to moderately moist cultivation or for general measurement on moist surfaces.

 Open the catalog to page 1

All Ahlborn Mess- und Regelungstechnik GmbH catalogs and technical brochures

  1. Certificates

    8  Pages

  2. Conductivity

    2  Pages

  3. pH-english

    4  Pages

  4. Trigger cable

    3  Pages

  5. RTA5-english

    1  Page

  6. RTA6-english

    1  Page

  7. Cases

    1  Page

  8. ODBC-english

    4  Pages

  9. Web server

    4  Pages

  10. PIMEX-english

    4  Pages

  11. Thermo-wires

    3  Pages

  12. FIA20-english

    2  Pages

  13. MI30-english

    2  Pages

  14. MI40-english

    2  Pages

  15. Pitot Tubes

    2  Pages

  16. Force-english

    3  Pages

  17. Displacement

    2  Pages

  18. Speed

    1  Page

  19. Flow

    2  Pages

  20. Wind sensor

    2  Pages

  21. Comfort Index

    2  Pages

  22. Sound Level

    1  Page

  23. Moisture

    5  Pages

  24. CO sensor

    1  Page

  25. WinControl

    2  Pages

*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.