Digital atmospheric pressure sensor FDAD 12 SA, for barometric pressure Integrated in ALMEMO® D6 plug General features and accessories, ALMEMO® D6 sensors see chapter ALMEMO® Measuring instruments Special features • Digital atmospheric pressure sensor with temperature compensation • Very accurate over a wide temperature range • The value measured for atmospheric pressure can also be used to compensate other sensors on the ALMEMO® device (programming comment *P). • Compact design, without pressure connection sleeve • Can be connected directly to the measuring instrument. • One measuring channel is programmed (at our factory). • Atmospheric pressure (mbar, AP, p) Digital atm. pressure sensor (integrated in ALMEMO® D6 plug) Measuring range Accuracy Operating range Refresh rate Supply voltage Current consumption 11/2025 • We reserve the right to make technical changes. Sensor material aluminum, nylon, silicone, Variants (including manufacturer’s test certificate) Order no. Digital atmospheric pressure sensor for barometric pressure, integrated in ALMEMO® D6 plug FDAD12SA DAkkS accredited calibration or factory calibration KD92xx atmospheric pressure for digital sensor, see chapter „Calibration certificates^. DAkkS accredited calibration meets all the requirements regarding test resources laid down in DIN EN ISO/IEC 17025. • Compact design - can be plugged directly onto measuring instrument. • Piezo-resistive pressure sensor - ensures high measuring accuracy. Measuring range 700 to 1050 mbar (total range 0 to 1050 mbar) Overload capacity Maximum 1.5 times final value Accuracy ±0.5 % of final value Temperature drift <±1 % final value at 0 to +60 °C Hose terminals 0 5 mm, 12 mm long Accessories Order no. Order no. Connecting cable, 0.2 meters ZA9060AK1 Extension cable, 5 meters ZA9090VKC5 Extension cable, 2 meters ZA9060VK2 Variants (including manufacturer’s test certificate) Order no. Pressure measuring connector for barometric pressure with pressure terminal sleeve FDA612SA DAkkS accredited calibration or factory calibration KD9xxx pressure for sensor or measuring chain (sensor + device), see chapter „Calibration certificates^. DAkkS accredited calibration meets all the requirements regarding test resources laid down in DIN EN ISO/IEC 17025.

Pressure measuring connector for differential pressure FDA 612 SR, FDA 602 S2K New compact design - can be plugged directly onto measuring instrument. Piezo-resistive pressure sensor - ensures high meas. accuracy. ! Advisory note when used in conjunction with ALMEMO® pressure measuring connector is very slightly higher (8.8 mm). As a result adjacent input sockets on the ALMEMO® device may be partly covered. However, the 1st input socket can always be used without restriction. Or, alternatively, the ALMEMO® pressure measuring connector can be plugged in at any input socket using connecting cable...