FHA 696 GF1
1Pages

{{requestButtons}}

Catalog excerpts

FHA 696 GF1 - 1

• The sensor operates on the principle of an open plate capacitor. The moisture contained in a material can be measured in terms of that material’s dielectric constants. • Moisture content can be determined in a matter of seconds - in wood chips or wood pellets, and sawdust, in grain and cereals, and other granulated materials. • The characteristics of the materials to be measured can be specified on a highly customized basis; a wide variety of granulates, e.g. various cereal types, can thus be measured Technical Data Measuring principle capacitive Measuring range 0 to 99.9 % water content as a weight percentage H2O Resolution 0.1% Measuring radius / penetration depth approx. 10 cm around the sensor Temp. range of material +5 to +40 °C Operating temp. range +5 to +40 °C Storage temp. range -20 to +70 °C Signal output ALMEMO® (voltage) Power supply 5 V from ALMEMO® measuring instrument Current consumption approx. 5 mA Dimensions Sensor head Extensions End piece Cable terminal Cable Ø = 22 mm, length = 200 mm Rounded tip 3 pieces, screw-on Ø = 18 mm, length = 300 mm Plastic Ø = 22 mm, length = 30 mm Mountable male connector on sensor head PVC, length = 2 meters with ALMEMO® connector The cable is led through the extension tubes and end piecet. Determining characteristics for special customer-specific materials 1. We need a sample of approx. 10 liters of your granulate (e.g. wood, cereal, plastic). This sample should be sealed in an air-tight package, e.g. shrink-wrapped in plastic film. 2. We use various dried samples to determine the characteristics of your particular material. 3. We then program these characteristics in the ALMEMO® connector for the moisture content probe.. Pro rata processing costs per material sample, net (service) Advisory note: If the material cannot absorb water (not hygroscopic), it will not be possible to measure its moisture content. In this case the processing fee we charge will be reduced. Sensor for measuring moisture in granulated wood chips and pellets comprising : Sensor head, 3 screw-on extensions, end piece, connecting cable 2 meters, with ALMEMO® connector programmed for wood chips (also programmable for wood pellets; if required, please indicate) including carry case FHA696GF1 Test block for FHA696GF for wood chips and wood pellets ZB9696PE22 10/2013 • We reserve the right to make technical changes. Sensor for measuring the moisture in materials FHA 696 GF1 For determining the moisture content in granulated materials such as wood chips, wood pe

Open the catalog to page 1

All Ahlborn Mess- und Regelungstechnik GmbH catalogs and technical brochures

  1. Product Catalog

    348 Pages

  2. FPAD 36-3

    2 Pages

  3. FLD7 33-UVE

    2 Pages

  4. FHAD 46-DTC2

    1 Pages

  5. ALMEMO® 204

    3 Pages

  6. AMiR 7834

    6 Pages

  7. ALMEMO® D6

    1 Pages

  8. MH8D46

    2 Pages

  9. FHAD46-7

    1 Pages

  10. FHA 646 R

    1 Pages

  11. Thermo-wires

    3 Pages

  12. ALMEMO® 5690

    10 Pages

  13. Product Catalog

    329 Pages

  14. CO2 sensor

    2 Pages

  15. FLA623

    3 Pages

  16. Pitot Tubes

    2 Pages

  17. FHAD 36 Rx

    4 Pages

  18. ALMEMO ® D6

    2 Pages

  19. FLA 613 VLK

    2 Pages

  20. FLAD23CCT

    2 Pages

  21. AMiR 7838

    6 Pages

  22. FD 8214

    2 Pages

  23. FMD7-60

    3 Pages

  24. T 820-6

    2 Pages

  25. ALMEMO 2490

    2 Pages

  26. ALMEMO ® 5690

    10 Pages

  27. ALMEMO ®

    3 Pages

Archived catalogs