11/2025 • We reserve the right to make technical changes. • The precision probe heads and the sensor shaft are made of metal. • The flow velocity is recorded with high accuracy. • Every vane anemometer is adjusted individually. The multipoint adjustment is saved within the ALMEMO® D6 plug. • Measurement operations carried out by a vane anemometer in air/gas are in practice nearly completely unaffected by environmental variables such as pressure, temperature, or humidity. The low dependence of the measured value on Nominal conditions 22 °C ±2 K, 1013 mbar Connection cable permanently connected cable, FEP/silicone shielded, 2 meters, with Lemo plug ALMEMO® adapter cable Lemo coupling cable, 0.2 meters, with ALMEMO® D6 plug Frequency measurement resolution 0.01 Hz Multi-point adjustment sensor specific, saved within the ALMEMO® D6 plug of the adapter cable density can be compensated. The density of the gas can be programmed within the ALMEMO® D6 sensor menu on the ALMEMO® V7 device. • The rugged construction is suitable for mobile as well as for stationary measurement operations. • The ALMEMO® D6 plug measures the frequency signal of the vane with high resolution. • One measuring channel is programmed (at our factory): flow velocity v (m/s). Refresh rate 0.5 seconds for all channels Averaging period 2 seconds, programmable from 2 to 100 s Supply voltage 6 to 13 VDC For more information about general features of the ALMEMO® D6 sensors, see chapter ALMEMO® Measuring instruments Lemo extension cable, length = 5 m, for FVAD 15-H120/-H140/-H220/-H240 /-MK5/-MK20 to extend the sensor cable ZB9915VKLH05 ALMEMO® extension cable, length = 2 m (see chapter 6) ALMEMO® extension cable, length = 5 m (see chapter 6) Extension set 0 25 mm, stainless steel, 3 tubes 350 mm each, 3 O-rings (material: FPM75), suitable for Extension set 0 16 mm, stainless steel, 3 tubes 350 mm each, 3 O-rings (material: FPM75), suitable for Tube adapter to impeller FVAD 15-HMKx Macro: 0 18 mm (impeller) to 0 16 mm (extension tube), stainless steel, length 30 mm ZV9915HMK DAkkS accredited calibration or factory calibration KV90xx, air flow, for digital probe, see chapter „Calibration certificates“. The DAkkS accredited calibration fulfills the requirements of DIN EN ISO/IEC 17025 for test equipment.

Air flow Digital precision vane anemometer mini FVAD 15 -H120 / -H140 • The construction type as a cylindrical probe is optimized for safely introducing the probe in a flow channel. Probe head and handle have the same diameter. Technical data: Version: mini, aluminum Probe head: Measured medium: air/gas Operative range: -20 to +125 °C (including cable) Pressure resistance: up to 6 bar overpressure Measuring range: refer to Variants Sensor shaft: Accuracy: ± (+0.5 % of final value sensor Sensor length: + 1.0 % of measured value) Cable exit: specific multi-point adjustment Cable length: aluminum,...

Air flow Digital precision vane anemometer macro FVAD 15 -HMK5 / -HMK20 • Anemometer with T-measuring head. • Large cross-sectional area. • Small measuring range available. • Very small start-up value. • Low inclined flow sensitivity. • For measuring medium air, pure gases or gas mixtures. head macro is used in a wide variety of applications Applications The digital precision vane anemometer with measuring hi to measure air velocity. • Measurements on ventilation, air conditioning and filtration systems. • Measurement of laminar flow and net measurements on large inlets and outlets. • Verification...