No. Date: Supersedes: Page: CUSTOMER ACCEPTANCE STANDARD BEAMED FIBERGLASS YARN FOR FILAMENT TAPE REINFORCEMENT DESCRIPTION Beamed Fiberglass yarn is an accumulation of parallel ends pulled from a creel and wound on flanged section beams. USE These beams are used in the manufacturing of parallel reinforced tape products. AVAILABLE PRODUCTS AND NUMBER OF ENDS Maximum Million End Yards by Beam Number Available Yarns Beam Number ECG75 1/0 620 0.7 Z, S or A ECG150 1/0 646 0.7 Z, S or A Table 1. Beam Type 9002 9004 Available Ends The customer’s order shall specify the twist directions desires, “S’ or “Z” or alternately spaced “S” and “Z” twists designated as “A” NOTE: To determine the available package for the ends and length required, the following procedure shall be followed: Calculate the number of million end yards (MEY) by multiplying the required ends times the required length. (Example 700 ends x 35000 yards=24500000 or 24.5 MEY This specification is subject to change without notice.

No. Date: Supersedes: Page: CUSTOMER ACCEPTANCE STANDARD 2. 3. Using the above chart(s), select the package having the nearest maximum MEY capacity exceeding the calculated MEY The applicable package per the example would be Package 9002, however, the product is likewise available on all other packages having a capacity greater that Package 9002. PHYSICAL PROPERTIES OF CONSTITUENT YARNS AND TEST METHODS Nominal Bare Glass Yardage 15000 7300 W-07 Ea Minimum Break Strength 5.7 4.0 S-1 Fb Nominal Yarn Diameter (in.) Nominal Yarn Build-up (in.) PACKAGE DESCRIPTIONS AND WORKMANSHIP CRITERIA See Advanced...