Quality System Certified ISO 9001 TK-SYRINGE Dimensions.doc Rev.00 Page 1 of 1 TK- Syringe device for clamp standard according BS 4825 Flush mount hygienic device features a compact design that allow to take sample of product from a tank or in-line in pharmaceutical sector. Before to sampling, the port may be sterilized with alcohol and then sampling takes place by simply penetrating the special silicone gasket with an hypodermic syringe. Once installed the syringable silicone gasket shut off flush with the inside tank wall with a zero dead leg. Availble in a unic size of 1”1/2 may be connected on standard clamp according BS 4825 or TK-Connections Cost reduction No product entrapment Easy to use and clean/sterilize Autoclavable Customized for your needs 1”1/2 TK-Connection fitted with TK-Syringe for Tank installation Design pressure TK holder 7 bar Design temperature TK holder 200°C Operating limits conditions : Max pressure sample liquid 0,5 bar Max sampling temperature 95°C Material : Double clamp port Blind end cap Syringable gasket Clamp assembly ASTM A 479 / ASTM A 182 – 316L ASTM A 479 / ASTM A 182 – 316L white silicone 60 shore FDA compliance AISI 304 stainless steel 1”1/2 clamp ferrule fitted with TK-Syringe In-line application Surface finish : Product contact surface are finish Ra<0,5 micron or better Marking: Each TK-Syringe is marked with Heat No. for full lot traceability Materials certification according EN 10204- 3.1B In the interests of development and improvement of the product, we reserve the right to change the specifications without prior notice. Aerre Inox S.r.l. Lottizzazione Gerola – 26010 FIESCO (CR) Italy Tel. +39. 0374. 370828 Fax +39. 0374. 370833 Website www.aerreinox.it E-mail [email protected]