Quality System Certified ISO 9001 13MHH clamp dimensions Rev.2.doc Page 1 of 1 Standard BS 4825 for pipe according ASTM A270 Wing nut tightened to = 2,8 Nm of torque Service Ratings are based on hydrostatic tests using Standard Buna material gaskets, with proper expansion of ferrules, assembly of joints and absence of shock pressure. For temperature above 121°C we recommend using 13MHP clamp only. Three segment heavy duty clamp 13MHHS available in size 12” Tube OD only Hydrostatic tests: not available Special Note concerning the limited use of PTFE gaskets: Psi / bar service ratings shown for clamps DO NOT APPLY to 1” and above tube OD sized connections incorporating any gaskets o f PTFE material. As PTFE material by nature is virtually incompressible and tends to ”cold flow” under normal operating conditions, PTFE gaskets, when used with any standard clamp, are likely to leak at pressures far below these published service ratings. To avoid possible leakage problems, we recommend contact us before considering the use of PTFE material and to discuss other viable alternatives. The above limitations do not apply to Fractional Sized %” and %” tube OD fittings and connections. In the interests of development and improvement of the product, we reserve the right to change the specifications without prior notice. Aerre Inox s.r.l. 26010 FIESCO Via Gerola n.4 -CREMONA- Italy Tel. +39.0374.370828 Fax +39.0374.370833 e-mail : [email protected] http :