AT324 Double Sided Differential PVC Tape General Description A black PVC film with the faced side coated with a permanent dispersion acrylic adhesive and the unfaced side coated with a removable acrylic adhesive, interleaved with a white siliconised paper release liner. • NEC (National Exhibition Centre) approved • Clean peel • Easy unwind • Conformable to awkward shapes • UV resistant Technical Details Typical Values Tape thickness (Excluding liner) 0.15mm Release liner weight 80gsm Release liner thickness 73 pm Adhesion to Steel Faced Side 6.0 N/cm NOTE Except where indicated otherwise, the figures stated are average values and should not be regarded as MAXIMUM or MINIMUM values for specification purposes. The Company reserves the right to improve products and any change in specification will result in a re-issue of the relevant ‘Technical Data Sheet’. Customers should satisfy themselves that the tape is suitable for their requirements whether after such modifications or otherwise. Please check that you have the latest issue of the ‘Technical Data Sheet’. All slitting and length tolerances are to British Standards. Before use the customer is advised to consult the Health & Safety Data Sheet produced by the company for this product, which is available on request. STORAGE Tapes stored below the minimum recommended temperature will require warming up to that level before use. Up to 24 hours may be required for this to take place. RoHS compliant Service Temperature Application Temperature Storage Temperature AFERA Association des Fabricants Europeens de Rubans Auto-Adhesifs. Adding more to adhesive tape Advance Tapes International Limited Westmoreland Avenue Thurmaston Leicester LE4 8PH England