LT-X
8Pages

LT-X (Lab-Therm) Space saving stackable incubator shaker

The Kuhner LT-X (Lab-Therm) incubator shaker has the same + Fits into any laboratory + Used in biotech and pharmaceutical capabilities as the larger ISF1-X and ISF4-X models. The industries incubator shaker was specially developed to address the + Accepts flasks up to 6 litres + Two units can be stacked - no special kits shaking needs of the biotechnology and pharmaceutical or tools required Humidity and CO2 control available industries. The practical size of the LT-X means it will fit in any laboratory. Extra space Exceptional chamber height means flasks up to 6 litres capacity can be...

Temperature minimum ambient + 10°C * optimised incubator shaker for cell culture + Improved temperature accuracy: Volume (empty) Weight (with cooling) I70 kg Interface, standard Interface, optional digital, analogue Ambient temperature • Shaking unit Tray, size Accuracy, absolute Active brake • Shaking motion Setting, digital Accuracy, absolute Principle of sensor capacitive Water refill automatic Principle of sensor Infrared, NDIR Mains connection

Options Multiple options for your shaker Cooling All Kuhner incubator shakers can be fitted with cooling. The refrigeration system is regulated by a fully digital PID control ensuring minimal energy consumption. The cooling is switched on only when required as determined by the chamber temperature and set point. Humidity control Humidity control is an important factor in successful fermentation. Evaporation from microtiter plates, or when cultivating in flasks for long periods (e.g. cell cultures), can be significantly reduced with humidification. CO 2 control CO 2 control is essential when...

Dual table ᕢ The dual table is an easy and economical way of doubling the shaking capacity. The dual shaking table consists of two levels. Each level will accept an E or EX size tray. However, with the dual table the shaking speed is limited to a maximum of 200 rpm. Perspex cover To prevent accidental operation of the controllers, the panel can be protected by a perspex cover. IQ-OQ Documentation IQ-OQ (Installation Qualification and Operation Qualification) is an equipment qualification required for GMP procedures. This service is available from Kuhner and can also be carried out at the...

To suit your application The universal tray can be fitted with clamps for Erlenmeyer flasks, test tube holders, microtiter plates, sticky mats, or custom made holders to suit your requirements. Rearranging these clamps and holders is quick and simple._ EX-tray with rubber mat The whole tray is covered with a rubber mat and is particularly suitable for shaking containers at low speed (e.g. blood bags). EX-tray with sticky mats A tray fitted with sticky mats is especially useful for flasks shaken at low speeds (up to 200rpm). The flask is placed directly on the sticky mat without the need for...

EX-tray for centrifuge tubes Q The use of centrifuge tubes (e.g. 50ml Falcon tubes and TPP 50m tubes) in cell culture screening is well established.This EX-tray has a capacity of 72 x 50ml centrifuge tubes (3 racks of 24). Holders for 600ml TPP tubes are also available. For a comfortable working height Kuhner offers floor stands for the LT-X. These are available in a choice of 400mm (2 x LT-X) or The Kuhner LT-X incubator shaker can be fitted with a shelf allowing cultivation in petri dishes. One or two shelves can be placed above the shaking table and fixed to the chamber walls with four...

Shakers & Accessories www.kuhner.com Adolf Kühner AG • since 1949 Dinkelbergstrasse 1 CH – 4127 Birsfelden ( Basel ) Switzerland