Applications: In-counter butcher blocks and cutting boards, work surfaces, and computer or printer shelves. Lock-Out Slide 110 lb. [50 kg.] load capacity Even Lengths 16"–22" [406 mm–559 mm] Total Necessary Side Space: .87" x 2 Lengths: 16"–22" Overall Slide Dimensions: .87" x 2.18" Minimum Drawer Height: 2.18" Load Rating: 110 lbs.* Rear Lift-Out Bracket Part Number 4010-0148-CL (Left Hand, Zinc Finish) Part Number 4010-0149-CR (Right Hand, Zinc Finish) Front Lift-Out Bracket Part Number 4010-0147-CE (Unhanded, Zinc Finish) Slot toward the rear on the right hand slide (2X). Bright electro-zinc (C) or black zinc (CB) plating Slide: 1.38" [35.1 mm] Slide with bracket: 2.18" [55.4 mm] Slide length less 0.12" [3.1 mm] 110 lbs.* [50 kg.] .87" [22.1 mm] Side Space (Left Hand Shown) Slide Length Slide Travel Handed slide, lock-out in the extended position. Easily disconnects for removal and/or cleaning of work surface * Load rating based on an 18" slide in an 18" wide drawer cycled 50,000 times. Part Slide Slide Number Length Travel

Installation Instructions 1. Refer to Figure 1 for cabinet hole locations. Install cabinet members using #8 screws as shown. Members with pockets are shelf members. Be sure slides are parallel. 2. Refer to Figure 2 (and chart below) for front and rear mounting bracket hole locations. Install screw through vertical slots. Part Number Slide Length E (Right Hand) Pilot Holes Extend the slides fully forward. Slides should lock. Install helf s by lowering the rear brackets through the rear slide pockets. See Figure 3. Lower shelf until front brackets snap into slide lanced out pockets. 4. Close shelf...