MODEL 2601 APPLICATIONS: Use model 2601 whenever a full extension, very low profile slide is required. Ideal for use in tool boxes, laboratory furniture, and store fixtures. Not suitable for flat mounting. This product is covered by U.S. (6,254,209) and various foreign patents issued and/or pending. Full Extension, Hold-In Detent Very Low Profile Up to 75-lb. [34 kg] Capacity** 0| This mounting hole is not accessible on model 2601-12 [300mm]. © This mounting slot is only available on model 2601-16 [400mm]. This mounting slot is not accessible on model 2601-16 [400mm]. Closed Position Flush or Under Finish Lengths Travel Height Load Rating Bright electro-zinc plating (C) or black zinc (CB) finish available Even lengths from 8'' to 22'' [200mm to 550mm] Full extension 1.03'' [26.3mm] See chart side space Mounting Hardware Movement Features .50'' +.030/ -.000 [12.7mm +0.8/ -0.0] Side #6 truss head screw Steel ball bearings Hold-in detent, silenced movement in and out Load rating based on a 16" wide drawer cycled 10,000 times.

Installation Instructions Slide Ordering Instructions Install the Cabinet Member Complete your slide order for model 2601 by specifying the following: 1. Mark a horizontal line in the cabinet sidewall at least 5/8'' [15.9mm] above the cabinet floor or at least 5/8'' [15.9mm] below the top of the drawer side. Mark a point on the line 2-3/8'' [60.2mm] in from the cabinet front. This will position the slide flush with the cabinet opening. For inset drawers, add the drawer front thickness to the 2-3/8'' [60.2mm] dimension. See Figure 1. Figure 1 Total Slides Required Slide Finish Slide Model Slide...