Concealed Hinge Flipper Door Slide ® Optional Detent-Out Feature APPLICATIONS: Concealed doors on entertainment centers, wall units, and cabinets. Use for horizontal or vertical applications. Finish Clear zinc (C) or black electroplate (CB^ Door Sizes 3/4" [19.0 mm] thick minimum to 7/8" [22.2 mm] thick maximum. Vertical doors 36" [914.4 mm] high by 24" [609.6 mm] wide. Horizontal doors 36" [914.4 mm] wide by 24" [609.6] tall. Lengths 12"-28" [305 mm-711 mm] Load Up to 25 lbs. [11.4 kg.] Also Optional detent-out feature (ordered as "DO") available. Designed to accept a variety of European hinges. MODEL 117 Door Sizes: Thickness 3/4" min.-7/8" max. Vertical 36"H X 24"W Horizontal 36"W X 24"H Load Rating: Up to 25 lbs.* Use for horizontal or vertical applications part number

Installation Instructions—Vertical Applications Without Partition Vertical Application/No Partition Front View Step 1. Spend a minute familiarizing yourself with the various terms in the drawings. Step 2. Attach the follower strip to the slides as shown in Figures 1 and 2. It is essential that a 90° angle exist between the follower strip and the slides. After the follower strip is attached, check to make sure the slides are parallel. If the slides are not parallel, they will not operate properly when installed in the cabinet. NOTE: The follower strip must be attached to the slides prior to the...

Installation Instructions—Vertical Applications With Partition Vertical Application/With Partition Step 1. Allow for an operating envelope as shown in Figure 3. A "pocket" is required to clear door and protruding hinge arms on a 3/4" [19 mm] thick door. See Dimension A in Figure 3. Step 2. To install and adjust hinge, the front of the partition should be inset approximately 2-1/2" [63.5 mm] from the back of the closed door. A = Mepla, 1-7/8" Salice, Blum [47.8] Grass Accuride Slide Cabinet Side Optional Partition Mounting Screw Pivot Block Step 3. Continue installation by following Steps 1 through...

Installation Instructions—Horizontal Applications For horizontal applications, follow the mounting instructions on Page 2 for Vertical Applications/Without Partition and rotate the cabinet view 90°. See Figure 6. Step 1. Fabricate the follower strip and attach to slides as indicated in Steps 2 and 3 and Figures 1 and 2. Figure 6 Door (Open Position) Cabinet Ceiling Step 2. Mount the hinge mounting plates to the follower strip as shown in Figure 2. Step 3. Mount the slide to the cabinet ceiling, making sure both slide rollers are located the same distance from the front of the cabinet. This will...