Undermount Center Mount 3/4 Extension APPLICATIONS: Use model 1029 whenever a center under mount, three-quarter extension slide is required. Use for kitchen, bath, and residential applications. MODEL 1029 Quick ReferenceOver all dimensions: 1.38" W x .38" T Load Rating: 35 lbs** Lengths: 13" - 27" Side View of Bracket Rear View of Bracket .18 [4.6] Mounting Bracket P/N 4010-0157-CE (1 Ea. Per Slide) Finishes Lengths Travel Load Disconnect Hardware Movement Ordering Instructions Part Number ** Load rating is based on an 18" slide in a 16" wide drawer cycled 50,000 times. Bright electro-zinc (C) or black zinc (CB) 13" to 27" [330mm to 686mm] See chart 35 lbs.** [16 kg.] Friction disconnect #8 slotted pan or slotted binding head screws Steel ball bearings Measure the drawer from the rear of the front panel to the rear of the back of the drawer. Using the drawer measurement, select slide from chart at right. Measure your cabinet depth and check it against tabulation for selected slide. Example: 17" [432mm] long drawer with 20" [508mm] cabinet, zinc finish, order C1029-119. Optional rear mounting bracket adjusts to fit various cabinet depths. Rear plastic socket and roller are optional and available directly from Bainbridge Manufacturing Company at (509) 745-9555.

Installation Instructions 2 To use model 1029 center slide, the drawer side must extend below the drawer bottom 1/4" [6.4mm]. See Figure 1. It may be necessary to cut a notch in the back overhang of the drawer, allowing the slide to fully extend to the back of the cabinet. NOTE: A shim should be used below the cabinet member to compensate for required drawer clearance. The thickness of the shim should provide sufficient clearance between the drawer bottom and bottom of the drawer side after the tacks have been installed. Example: 3/8" [9.5mm] drawer side would require a 1/8" [3.2mm] shim. See...