CONTROLS CONFIDENTIAL INFORMATION 20A INDUSTRIAL MAINS PHASE POWER CONTROLLER The MPC32 is an industrial Phase Power Controller designed for panel mounting and requires a 10 mm hole. Undo the nut on the bush and push the bush through the panel from the rear. Use the nut to secure the assembly onto the panel. If the control will drive more than 5A make sure that the panel is a good conductor of heat with suitable ventilation and use a heatsink compound between the panel and the MPC32 interface. In case of any doubts contact Abbey Electronics. Ensure adequate earthing using the earth stud and use with suitable RFI filter. This product complies with the requirements of the Low Voltage Directive. Size of Facia:- 50.0 x 50.0 Size of Control: 55 x 56 x 28 ABBEY Electronics MPC32A AC POWER CONTROLLER Absolute maximum ratings:-Voltage:-Current:-No heat sink: Heat sink 1°C/W or better: Non repetitive surge: Apply Live to the brown wire and connect the load between red wire and neutral. Ensure the controller is properly earthed through the Earth-Stud or Yellow/Green earth wire. Use with heatsink compound for good thermal transfer. Suitable RFI filter should be used to ensure EMC compliance. MADE IN THE UK +44-1942-227652 ALL RESISTORS 0 25U 5X ALL ZENERS 0 5U ALL DIMENTIONS IN ma DIM'S TO 1DP= ±0 1 ■■ DIM'S TO 2DP= 10 02 am ANGLES TO ±0 5° SCALE = 100X UNLESS STATED OTHERUISE