FL4503 (FL4502) ELECTRONIC IGNITION CONTROLLER FOR POOL HEATERS - 1 Pages

Add to MyDirectIndustry favorites
FL4503 (FL4502) ELECTRONIC IGNITION CONTROLLER FOR POOL HEATERS

Catalog excerpts

The Fx4 is a programable electronic ignition Full Sequence Controller for gas burning appliances which enable instant configuration to any OEM requirement. It provides ionisation flame detection and offers a choice of separate or combined ignition and flame detection electrodes. It can be supplied with any working voltage in the range 3V (aC or DC) up to 230V 50/60Hz. Housed in a very compact IP20 enclosure, the control can be mounted in any orientation. ABBEY ELECTRONICS Fx4vnn Electronic Ignition Full Sequence Control Power: Frequency: Temperature: Flame Detection: Configuration Code: Earth Neutral Live All the main functions of the Fx4 such as Pre-Purge, Post-Purge, Inter-Purge, Safety Time, Ignition Attempt, Burner Configuration, Pilot Type are fully programmable and can be immediately programmed into stock boards and shipped to the OEM. Of course, the operating voltage can be specified as well. Altogether, the Fx4 can electrically mimic practically any ignition unit on the market today. This makes it an idea control for both new and legacy products. Connection to the Fx4 is via a 2-part 10 way connector. The board should be wired as shown above for Pilot application. The flame should be sensed on the pilot for permanent pilot application. For dual probe (separate spark/flame sensing) operation connect SR (pin 1) to earth (pin 3). For single probe (combined spark/flame sensing) connect SR (pin 1) to FP (pin 4). The spark electrode will thus sense flame as well. The OEM should observe all the normal rules and regulations governing electrical wiring and safety. Title:- WIRING DIAGRAM FOR Fx4

 Open the catalog to page 1

All Abbey Electronic Controls catalogs and technical brochures

  1. AEC

    1 Pages

  2. WSX53

    4 Pages

  3. FX37FSA

    1 Pages

  4. FX37-P16

    1 Pages

  5. WSX53

    4 Pages