Catalogs >
Aanderaa Data Instruments AS >
Mira Visibility Sensor 3544/3544 EX (forward scattering)

Mira Visibility Sensor 3544/3544 EX (forward scattering)
2Pages

Catalog excerpts

Mira Visibility Sensor 3544/3544 EX (forward scattering) - 1

Mira Visibility Sensor 3544/3544 EX (forward scattering) Visibility in the atmosphere is of great interest for road and sea traffic and in aviation. The MIRA Visibility Sensor 3544 is designed to fulfill the demand for a small, low power unit to be operated with Aanderaa Measuring Stations. Visibility is often limited by fog and haze and the sensor is de ign d to detect these factors. s e The sensor consists of an aluminum body containing all necessary solid state electronics and two vertical legs. It is furnished with a standard Aanderaa meteorological sensor foot. It is a rugged, watertight, corrosion free and solid state sensor with minimum maintenance requirements. In one leg of the body, an infrared (IR) light emitting diode is installed at an angle of 25 degrees. The opposite leg contains an IR photo detector. The diode and the photo-detector are protected against clogging by a cover. The sensor has two operating modes, Normal and Fast sampling Modes, which can be selected by the Mode Switch. In Normal Mode, used when the sensor is solar-cell or battery powered, the sensor transmits an infrared light beam every minute. If fog or haze are present, forward scattered light from the particles will be detected by the photocell thus giving a signal with good correlation to the visibility in the ambient air. The photo current which is proportional to the scattered light, is amplified, averaged, converted to visibility and stored in the sensor as a 10 bit digital signal ready to be read by the Sensor Scanning Unit or data logger. If the sensor is powered from Mains, fast sampling mode can be used to increase the number of samples taken in a measurement cycle. This will improve the accuracy of the sensor. In this mode the light beam is transmitted every 6 seconds. To avoid false scattering from surrounding objects, the sensor must have free horizontal distance of at least 15 cm and a free vertical distance of more than 1 meter. This is taken into consideration when installing the sensor on the sensor arm of a Road Weather Station 4030 or Automatic Weather Station 2700. For direct connection to a Programmable Logic Controller PLC, a Signal Converter, part no. 3429, is available for converting the data to 0-5VDC and 4-20mA signals.

Open the catalog to page 1

Mira Visibility Sensor 3544/3544 EX (forward scattering) - 2

235 mm MIRA Visibility Sensor 3544 Serial No. Signal Type: SR10 AANDERAA INSTRUMENTS BERGEN, NORWAY Standard sensor foot Mode Switch (see below) IR Detector Infrared light beam Detecting Area PIN CONFIGURATION Receptacle, exterior view; pin = ; bushing = – 9 volt Bridge voltage Control voltage System ground The sensor is also available as an -certified sensor; contact factory for prices. The sensor has nominal calibration coefficients which are the same for all 3544 sensors. To convert raw data reading (N) from Datalogger 3660 to corresponding engineering units, use the following general...

Open the catalog to page 2