Series PGeared-drive Prismatic-column Drills With Electromagnetic Clutch Automatic Feed Control The P series Industrial Drilling Machines are built with an extra heavy-duty base and worktable to handle large and heavy work pieces. Standard Features and Equipment: • • • • • • • • • • • • • • • • • • • • • Drilling capacity in steel: 2.75" (70mm) maximum Drilling capacity in cast iron: 3.14" (80mm) maximum Tapping capacity in steel: 2.51" (64mm) maximum Tapping capacity in cast iron: 2.68" (68mm) maximum Automatic feed reversing system for tapping on “RS” models Adjustable vertical position of head by geared-motor Large worktable with 3 T-slots Hardened and ground high quality steel gears Gear box lubrication by automatic pump Guide ways lubricated by manual pump Speed plate and selecting levers on front of head Coolant tank and pump in machine base Automatic feed and cut-off by electromagnetic clutch Work light Front hand wheel for fine feed work Depth scale and adjustable depth stop Built-in low voltage electrical equipment in column rear Emergency STOP Automatic tool ejector Forward and reverse turn push buttons Drill guard with microswitch Optional Equipment: • Automatic pitch control tapping with single speed brake motor • Automatic pitch control tapping with pneumatic rapid approach • Master guide spindle and nut set for automatic pitch control tapping • Pneumatic counterbalance with rapid approach and retract • Pneumatic counterbalance with rapid approach and retract for tube and and profile drilling • Pneumatic counterbalance with rapid approach and retract with pitch controlled tapping • 50% lower feed range • Mechanical spotface device • Pneumatic counterbalance • Multi-spindle head guide rod • Union, dragging cone and assembly for multi-spindle head • START-STOP and emergency STOP pendent control • Pendant control panel with all functions • Cross slide table • ISO-40 spindle with quick change nut (models BP-40,50,70) • ISO-50 spindle with quick change nut (models BP-70 only) Page 4 All SeriesP models are supplied with side protection panels with front doors except those equipped with a cross table. View of left side of machine head showing lifting equ

“RS” models are equipped with automatic feed reversing system for tapping. Standard motor: 1800 rpm Model Spindle speeds (rpm) Optional spindle motors Model Motor Speed range