Catalogs >
4B Braime Components >
Vise Splice Elevator Belt Joiners

Vise Splice Elevator Belt Joiners
1 / 1Pages

Catalog excerpts

Product Datasheet 4B Vise Splice Elevator Belt Splices & Fasteners Vise Splice Non-Ferrous (4BVS-AB) APPLICATION 4B Vise Splices are mechanical splices for use on most PVC and rubber elevator belts. Each splice unit is made of three pieces. The outside plates have two different gripping areas. The ribbed gripping area is mounted towards the face of the belt. The opposite end has a series of both longitudinal and axial “teeth.” The center plate is symmetrical and cannot be improperly installed around its elongated center hole. The splice functions by using the tension supplied by the belting. This tension on the belt ends pulls the outer plates apart, and forces gripping pressure towards the teeth on the splice unit. The greater the belt tension, the more pressure is exerted on the gripping teeth at the forward end of the splice. NON-FERROUS ► Usable on Belts of up to 800 PIW Tensile Strength ► Non-Sparking, Non-Corroding & Non-Rusting ► Bronze Colour ► 2.9 lbs. Each FERROUS ► Usable on Belts of up to 600 PIW Tensile Strength ► Silver Colour ► 2.6 lbs. Each Vise Splice Ferrous (MBG2) Elevator & Conveyor Engineering Design Service FEATURES ► For Belts 600 to 800 PIW Tensile Strength ► Use on PVC and Rubber Belting ► For Belts 600 to 800 PIW Tensile Strength ► Non-Sparking (Non-Ferrous Version) ► Max. Temperatures: Ferrous 315°C, Non-Ferrous 260°C ► Each Splice Accommodates 5cm of Belt Width Center Piece PART NUMBERS/ACCESSORIES ► MBG2 Vise Splice CI ► 4BVS-AB Vise Splice AB ► MBGT-9 Belt Power Punch Tool ► 4BVS-TT Punch Template Tape (Supplied with Splice) 9/16” Diameter Grade 5 Bolt & Lock Nut (Supplied) PVC or Rubber Belting - Do Not Use on Manlifts or Wing Pulleys - Never Re-Use Hardware: Always Use New Bolts, Nuts & Washers Please refer to instruction manual for correct installation. Information subject to change or correction. October 2017

Open the catalog to page 1