SpeedMaster Speed Switch Calibration Testing Device
2Pages

{{requestButtons}}

Catalog excerpts

SpeedMaster Speed Switch Calibration Testing Device - 1

Product Datasheet Speed Master™ with Pulse Pilot SpeedMaster™ with Pulse Pilot Speed Switch Calibration and Testing Device The SpeedMaster™ with Pulse Pilot provides independent, real time, and complete verification of an entire speed monitoring system to ensure that alarms and shutdowns are working as expected. METHOD OF OPERATION The SpeedMaster™ operates in two modes. Input mode is used to measure the pulse rate at normal speed. Output mode will allow the user to input pulses to the sensor for testing purposes. The Pulse Pilot fits in the gap between the sensor and cover on the Whirligig® (see below). The Pulse Pilot will have no effect on the operation of the speed switch until it is connected to the SpeedMaster™ and set to output mode. FEATURES ►Calibration Testing ►Exact Alarm Point Testing ►Exact Shutdown Point Testing ►Incremental Output Rates ►Easy To Read Display ►No Need To Modify Speed Switch Assembly For Testing PART NUMBERS ►SM2 SpeedMaster ►PP1 Pulse Pilot 4B COMPATIBLE SENSORS & ACCESSORIES ►M8001V10C M800 Elite Speed Switch ►M3001V10AI M300 Slipswitch (2 Wire) ►M3005V10AI M300 Slipswitch (5 Wire) ►M1001V10A M100 Stopswitch ►P3001V34AI P300 Inductive Proximity Switch ►WG1A-BR Whirligig® with 1 Target ►WG2A-BR Whirligig® with 2 Targets ►WG4A-BR Whirligig® with 4 Targets ►WG8A-BR Whirligig® with 8 Targets ►MAG2000M Mag-Con™ Magnetic Connector (Optional) Whirligig® is a registered trademark of 4B Components, Ltd. SpeedMaster and Mag-Con are trademarks of 4B Components, Ltd. Information subject to change or correction. Jan 2016

Open the catalog to page 1
SpeedMaster Speed Switch Calibration Testing Device - 2

Product Datasheet Speed Master™ with Pulse Pilot BRAIME DIMENSIONS Pulse Pilot Shown in Operating Position between M800 Elite Speed Switch and Whirligig® Target TECHNICAL SPECIFICATIONS Speed Master ™ Supply: Control: Input Mode Indication: Output Mode Indication: Display: Power On: 4 AA Alkaline Batteries (Included) Push Button Red LED Green LED Yellow OLED Display (Shaft Speed / Pulses Per Minute) Plug in Pulse Pilot (top of unit) and press power button Unit powers off automatically if no buttons are pressed for 5 minutes. Unit can be turned off manually by pressing the power button....

Open the catalog to page 2

All 4B Braime Components catalogs and technical brochures

  1. Euro Bolt

    1 Pages

  2. 4B Tacho

    2 Pages

Archived catalogs