TDS Rev 1.0 Technical Data Sheet: ThermaX™ PEI GF30 [Made using ULTEM™ PEI] Physical Properties Density Mechanical Properties Tensile Strength, Yield Tensile Modulus Tensile Elongation Flexural Strength Flexural Modulus Thermal Properties Glass Transition Temperature (Tg) Deflection Temperature at 0.45 MPa (66psi) Fire Testing* Flamability Rating (*Base Resin) Printed Specimen Conditions Printer: Open Source FDM/FFF Nozzle: 0.4mm Layer Height: 0.25mm Infill: 100%, +/- 45° Extrusion Temp: 380-410°C Bed Temp: 130-140°C Specimen Orientation: XY Flat www.3dxtech.com ULTEM™ is a registered trademark of Sabic IP Disclaimer: The technical data contained on this data sheet is furnished without charge or obligation and accepted at the recipient’s sole risk. This data should not be used to establish specifications limits or used alone as the basis of design. The data provided is not intended to substitute any testing that may be required to determine fitness for any spe