カタログ >
Tsubakimoto Chain/つばき >
Tsubaki Plastic Modular Chain WT2705-K Type

Tsubaki Plastic Modular Chain WT2705-K Type
1 / 2ページ

カタログの抜粋

Tsubaki Plastic Modular Chain WT2705-K Type - 1

Innovation in Motion TSUBAKI Introducing the WT2705-K, a new closed-type addition to the Tsubaki WT2700 Series of easy-maintenance chains. This chain’s plug-clip pin retention system enables easy connection and disconnection of modules and reuse of pins Model Numbering Chain type Chain pitch Chain type WT 27 05 Chain widthK24 Chain material 27: 27.2 mm 05: Closed type Note: Do not leave spaces between letters and symbols. Number denotes width in inches. Multiply the number by 25.4 to convert it into millimeters. Example: 24 x 25.4 = 609.6 mm B: Standard (blue) LFB: Low Friction/ Wear Resistant (brown) HTW: Heat Resistant (white) Chain material Note: 1. Values for chain strength are at an ambient temperature of 20°C and assume that tension acts uniformly over the entire chain width. The values in the table above are for chain that is one meter (1 m) in width. To calculate values for other chain widths, multiply the chain width in question by the chain strength for one-meter (1 m) wide chain. 2. Operating temperature of (60) is for wet conditions. 3. Contact a Tsubaki representative for chain specifications (materials) other than the above. 4. Plug-clip color is yellow (material: polyacetal) for Standard and LFB chains and blue (material: polypropylene) for HTW chain. 5. Max. allowable speed: 50 m/min. 6. Allowable load graph is the same as that for WT2706-K chain. Please refer to the Tsubaki Plastic Modular Chain WT2706-K brochure for the allowable load graph.

カタログの1ページ目を開く

Tsubaki Plastic Modular Chain WT2705-K Type - 2

Note: 1. Standard chain width is 76.2 mm (3 inches). Custom chain widths and widths greater than 1,524 mm are available upon request. 2. Chain widths can be configured in 8.5 mm (1/3-inch) units, starting from a minimum width of 50.8 mm. 3. Chain width X shown is a nominal width. Actual width range is +0.7% at 20°C operating temperature. Chain width is subject to expansion or contraction with changes in temperature. Expansion/contraction rate is 0.00015/°C for Standard and LFB chains and 0.00011/°C for HTW chains, based on a reference temperature of 20°C. Heat Resistant Series Low...

カタログの2ページ目を開く