カタログ >
TOPWAY LCD >
TM035PDHG09

TM035PDHG09
1 / 42ページ

カタログの抜粋

MODEL VERSION: SPEC VERSION : ISSUED DATE: □Preliminary Specification ■Final Product Specification TIANMA Confirmed : Prepared by Suhao_ni Yunchao_kang Xiaoxu_li Huixuan_chen This technical specification is subjected to change without notice The information contained herein is the exclusive property of TIANMA MICRO-ELECTRONICS Corporation and shall not be distributed, reproduced, or disclosed in whole or in part without prior written permission of TIANMA MICRO-ELECTRONICS Corporation. Page

カタログの1ページ目を開く

The information contained herein is the exclusive property of TIANMA MICRO-ELECTRONICS Corporation and shall not be distributed, reproduced, or disclosed in whole or in part without prior written permission of TIANMA MICRO-ELECTRONICS Corporation. Page 2 of 42

カタログの2ページ目を開く

Issued Date Description Preliminary Specification Release Editor Yanzhong_kong The information contained herein is the exclusive property of TIANMA MICRO-ELECTRONICS Corporation and shall not be distributed, reproduced, or disclosed in whole or in part without prior written permission of TIANMA MICRO-ELECTRONICS Corporation. Page 3 of 42

カタログの3ページ目を開く

General Specifications Feature Display Spec. Mechanical Characteristics Electrical Characteristics Size Resolution Technology Type Pixel Configuration Pixel pitch(mm) Display Mode Surface Treatment Viewing Direction Gray Scale Inversion Direction 3.5 inch 320(RGB) x 480 a-Si R.G.B. Vertical Stripe 0.153(H)x0.153(V) TM with Normally White HC 6 o'clock 12 o'clock LCM (W x H x D) (mm) Active Area(mm) With /Without TSP Matching Connection Type LED Numbers Weight (g) Interface Color Depth Driver IC Note 1: Viewing direction for best image quality is different from TFT definition. There is a 180...

カタログの4ページ目を開く

Input/Output Terminals Ground A supply voltage to the digital circuit. Connect to an external power supply of 1.65 ~ 3.6V. A supply voltage to the analog circuit. Connect to an external power supply of 2.5 ~ 3.6V. supply of 2.5 ~ 3.6V. Select the interface mode Reset input signal Frame synchronizing signal Fix to DGND level when not in use. Line synchronizing signal Fix to DGND level when not in use. Dot clock signal Fix to DGND level when not in use. A data ENABLE input signal Fix to DGND level when not in use. Data Bus VSYNC HSYNC The information contained herein is the exclusive property...

カタログの5ページ目を開く

Ground Serial data output Leave the pin open when not in use. serial data input/output bi-direction pin Fix to DGND level when not in use. serve as a read signal Fix to IOVCC level when not in use. (WR) Write data enable pin in DBI Type B (SCL) Write data enable pin in DBI Type C If no used, please connect this pin to IOVCC Data/command selection pin If no used, please connect this pin to IOVCC Chip select signal If no used, please connect this pin to IOVCC NC Ground O---Output P----Power/ Ground NC---Not Connected Table 2.1 Select the interface mode The information contained herein is the...

カタログの6ページ目を開く

Absolute Maximum Ratings GND=0V Item Power Voltage Logic supply voltage Operating Temperature Storage Temperature Absolute Humidity Absolute Maximum Ratings Note1: 1. Even if the absolute maximum rating of one of the above parameters is exceeded only for a short while, the quality of the product may be degraded. Therefore, be sure to use the product within the range of the absolute maximum ratings. 2. Do not apply to automotive products. The information contained herein is the exclusive property of TIANMA MICRO-ELECTRONICS Corporation and shall not be distributed, reproduced, or disclosed...

カタログの7ページ目を開く

Electrical Characteristics 4.1 LCD module Ta=25℃ Item Logic Signal Input /Output Voltage Power Supply Voltage Input High Level Signal Voltage Low Level Output High Level Signal Voltage Low Level Black Mode Sleeping Mode (Panel+LSI) Power Consumption Table 4.1 LCD module electrical characteristics Notes: 1. Ta = -40 to 85 °C (no damage up to 85℃ (at maximum)), IOVCC=1.65V to 3.6V, VCI=2.5V to 3.6V, DGND=0V. 2. Supply the digital IOVCC voltage equal to or less than the analog VCI voltage. The information contained herein is the exclusive property of TIANMA MICRO-ELECTRONICS Corporation and...

カタログの8ページ目を開く

4.2 Backlight Unit Item Symbol Forward Current IF Forward Voltage VF Backlight Power Consumption WBL LED lifetime Note1: Remark 1 LED 1 LED 6 LEDs in parallel Figure below shows the connection of backlight LED. Note 2: 1LED: VF =3.2V I =20mA F Note 3: : IF is defined for one LED. Optical performance should be evaluated at Ta=25℃ only. If LED is driven by high current, high ambient temperature & humidity condition. The life time of LED will be reduced. Operating life means brightness goes down to 50% initial brightness. Typical operating life time is estimated data. 4.3 Block Diagram The...

カタログの9ページ目を開く

Timing Chart 5.1 DBI Type B 5.1.1 DBI Type B Timing Characteristic The information contained herein is the exclusive property of TIANMA MICRO-ELECTRONICS Corporation and shall not be distributed, reproduced, or disclosed in whole or in part without prior written permission of TIANMA MICRO-ELECTRONICS Corporation. Page 10 of 42

カタログの10ページ目を開く