winder series W400 / W500 / W600 calendering
1 / 2ページ

カタログの抜粋

winder series W400 / W500 / W600 calendering - 1

WINDING TECHNOLOGY SERIES W400 / W500 / W600 CALENDERING Series W400 / W500 / W600 for calendering lines Series W400 / W500 jumbo roll winders can produce rolls with diameters of up to 2,000mm, which minimises the downtimes caused by roll changes in inhouse thermoforming applications. Each winder consists of two A-frame winding trolleys with 3- or 6-inch pneumatic winding shafts. The twin-trolley principle means that while one trolley is in active operation, the other is on stand-by for a roll change. the control panel and the winding speed accelerated thus releasing the lm stored in the accumulator. Series W600 cantilever winders operate according to the same principles as mentioned above, although xed winding stations with cantilever shafts are used instead of A-frame winding trolleys. This allows simple roll removal using a manually operated forklift, which again eases the burden on the machine operators. Series W400 winders In the case of inline, part-bobbin slitting, a maximum of three webs can be produced. The winders are arranged in sequence and combined with one upstream accumulator. This is activated during bobbin changes and takes up the lm, while all the subsequent take-off units and winders are stopped. As a result of their design, the winders are easy and safe to operate. Pneumatically actuated cross cutting stations are located above each of the winders and these cut and remove the web automatically in accordance with the pre-set length. The operator merely has to attach the sheet onto a new core and then presses a foot pedal so that a few layers of sheet are wound on. The winder can then be restarted from Highly economical model with A-frame winding trolleys for single web operation Comfortable multi-web winder with A-frame trolleys for reliability of operation Cantilever design for best operator convenience Used mainly for PET, PP and PS sheet lines for smaller roll diameters AUSTRIA - EUROPE EMAIL: SML@SML.AT

カタログの1ページ目を開く
winder series W400 / W500 / W600 calendering - 2

WINDING TECHNOLOGY SERIES W400 / W500 / W600 CALENDERING hydraulic drive electric drive hydraulic drive electric drive Thickness range electric drive Nominal width hydraulic drive electric drive hydraulic drive electric drive Mechanical speed Maximum roll diameter We reserve the right to technical modications. Printed 10/2010. electric drive AUSTRIA - EUROPE EMAIL: SML@SML.AT

カタログの2ページ目を開く

SML Maschinengesellschaftのすべてのカタログと技術パンフレット

  1. HYGIENE FILM

    14 ページ

  2. STRETCH WRAP

    18 ページ

  3. COATING LINES

    2 ページ

  4. PET / R-PET SHEET

    28 ページ

  5. CAST FILM LINES

    32 ページ

  6. SERIES W4000 CAST

    2 ページ

  7. CPP EXTRUSION

    2 ページ

  8. winder 2000

    2 ページ

  9. SML

    15 ページ

  10. Spinning lines

    16 ページ

  11. Coating lines

    12 ページ

  12. Sheet lines

    9 ページ

  13. Cast film lines

    20 ページ