カタログの抜粋

Applicable for the high-temperature environments Ambient temperature : Max. 45°C Inlet air temperature : Max. 65°C (24% increase compared to the current model)
カタログの1ページ目を開く
Refrigerated Air Dryer IDF Series temperature environments New stainless steel heat exchanger helps reduce the load of the compressor
カタログの2ページ目を開く
Refrigerated Air Dryer IDF Series Series Variations Model Rated inlet condition Rated ambient temperature Port size Optional accessories Auto Drain Valve Longer life, Higher resistance to foreign matter Non-sliding part reduces the catching of foreign matter Shape prevents condensate accumulation Diaphragm type Poppet type Condensate and foreign matter are discharged completely. Easier maintenance One-touch mounting and removal of the bowl is possible without using any tools. Release the lock by sliding the lock button down while holding the body. Then, rotate the bowl guard and pull down...
カタログの3ページ目を開く
Refrigerated Air Dryer IDF Series Protect Pneumatic Equipment from Moisture! An air dryer removes the vapor from the moist compressed air delivered by the compressor and prevents it from causing the pneumatic equipment to fail. ¡ alfunctioning of valves and M actuators caused by dripping grease Effects of moisture on equipment ¡Generation of water droplets ¡ ecomposition of auto drain caused D by rusting inside pipes Main line filter Mist separator Control panel The malfunction of air bearings of 3D measurement device, etc. Washing machine
カタログの4ページ目を開く
Read the correction factors ® to © suitable to the operating conditions. *1 Values obtained from the table below Corrected air flow capacity = 6.0 m3/min (ANR) 1 (0.78 x 1.05 x 0.92 x 1.00) = 7.96 m3/min (ANR) The 60 Hz power supply frequency model with an air flow capacity which exceeds the corrected air flow capacity of 7.96 m3/min (ANR) is the IDF70. ^ Calculate the corrected air flow capacity. Obtain the corrected air flow capacity from the following formula. Corrected air flow capacity = Air flow rate 1 (Correction factor @ x ® x © x ©) ^ Select the model. Select the model with air...
カタログの5ページ目を開く
Replacement Parts Voltage Symbol Options Symbol * When multiple options are combined, indicate symbols in alphabetical order. Dustproof filter Auto Drain Replacement Part Nos. Element Dustproof Filter Replacement Part Nos. Description *1 A bowl O-ring is included. A One-touch fitting for connecting the drain tube is not included.
カタログの6ページ目を開く
Correction of Air Flow Capacity Refrigerated Air Dryer IDF Series Inlet air pressure [MPa] Outlet air pressure dew point [°C] MPa Model Specifications Calculation example: The air flow capacity when the dew point of the IDF60 is set to 10°C under the following conditions is calculated. [Operating conditions: Inlet air temperature: 35°C, Ambient temperature: 35°C, Inlet air pressure: 0.6 MPa, Power supply frequency: 50 Hz] 5.3 m3/min (ANR) x 1.00 x 0.94 x 0.92 = 4.6 m3/min (AnR) 1 The operating range does not guarantee use with normal air flow capacity. *2 ANR indicates the following set of...
カタログの7ページ目を開く
IDF Series Construction (Air/Refrigerant Circuit) Humid, hot air coming into the air dryer will be cooled Evaporation thermometer down by a cooler re-heater (heat exchanger). Water condensed at this time will be removed from the air by an auto drain and drained out automatically. Air separated from the water will be heated by a cooler reheater (heat exchanger) to obtain the dried air, which goes through to the outlet side. Cooler re-heater Ball valve Auto drain Capillary tube High pressure switch Volume control valve Pressure switch Drain outlet Accumulator Compressor for refrigeration...
カタログの8ページ目を開く
In addition to power supply connection, terminal blocks for operating, error, and remote operation signals are available. • The operating and error signals are no-voltage contact style. Operating signal...During operation: contact “close”, During stop: contact “open” Error signal.During error: contact “close”, During stop: contact “open” Contact capacity.Rated load voltage: 240 VAC or less/24 VDC or less Max. load current: 5 A (Resistance load)/2 A (Induction load) Min. applicable load: 20 VDC, 3 mA • Power supply voltage is applied to the remote operation contact. The external switch is to...
カタログの9ページ目を開く
IDF Series Specific Product Precautions 1 Be sure to read this before handling the products. Refer to the back cover for Safety Instructions. For air preparation equipment precautions, refer to the Handling Precautions for SMC Products and the Operation Manual on the SMC website: http://www.smcworld.com |_Power Supply • Avoid locations where the air dryer will be in direct contact with wind or rain. (Avoid locations where relative humidity is 85% or more.) • Avoid locations where water, water vapor, salt water, or oil may splash on the product. • Avoid locations where dust or other...
カタログの10ページ目を開く
IDF Series Specific Product Precautions 2 Be sure to read this before handling the products. Refer to the back cover for Safety Instructions. For air preparation equipment precautions, refer to the Handling Precautions for SMC Products and the Operation Manual on the SMC website: http://www.smcworld.com Protection Circuit A Caution When the air dryer is operated in the following cases, the protection circuit will activate, the light will turn off and the air dryer will come to stop. • The compressed air temperature is too high. • The compressed air flow rate is too high. • The ambient...
カタログの11ページ目を開く
Safety Instructions These safety instructions are intended to prevent hazardous situations and/or equipment damage. These instructions indicate the level of potential hazard with the labels of “Caution,” “Warning” or “Danger.” They are all important notes for safety and must be followed in addition to International Standards (ISO/IEC)∗1), and other safety regulations. Caution indicates a hazard with a low level of risk which, if not avoided, could result in minor or moderate injury. Warning indicates a hazard with a medium level of risk which, if not avoided, could result in death or...
カタログの12ページ目を開くSMC PNEUMATICのすべてのカタログと技術パンフレット
-
Vacuum Unit 2024
99 ページ
-
Air Cylinder CJ2 Series
117 ページ
-
AS-FS Series
36 ページ
-
MHL2 Series
24 ページ
-
JCM Serie
18 ページ
-
EX245 Series
12 ページ
-
5 Port Solenoid Valve VQ
79 ページ
-
SY
268 ページ
-
5-p0979-0980-hep500
2 ページ
-
5-p0977-0978-aep100
2 ページ
-
5-p0966-0971-lmu
5 ページ
-
5-p0960-0966-alb900
6 ページ
-
5-p0956-0960-ald600
5 ページ
-
5-p0948-0950-al800
3 ページ
-
es70-44c-vx2
52 ページ
-
es50-37-kq2
124 ページ
-
ex-pcw
23 ページ
-
1-p2124-2152-ex510
29 ページ
-
1-p2111-2122-ex500
12 ページ
-
1-p2063-2073-ex260
11 ページ
-
4-p0147-0178-msu-mds
32 ページ
-
es20-230b-crb2
59 ページ
-
1-p1869-1878-vp3145
10 ページ
-
VP300/500/700 series
42 ページ
-
1-p1789-1829-vqz100
41 ページ
-
1-p1727-1788-syj300
62 ページ
-
5 Port Solenoid Valve S0700
111 ページ
-
5 Port Solenoid Valve VF
59 ページ
-
5 Port Solenoid Valve SV
127 ページ
-
VH
9 ページ
-
CUJ
41 ページ
-
AL
3 ページ
-
kj mm
9 ページ
-
AQ
4 ページ
-
SY3000/5000-X13
2 ページ
-
Series MB
24 ページ
-
Series LES
23 ページ
-
Series LEFB
16 ページ
-
Series PF3W
28 ページ
-
Series IDG?A/IDG
56 ページ
-
Floating Joint
7 ページ
-
Series IZS40/41/42
32 ページ
-
Series LEY
7 ページ
-
Series VHS
12 ページ
-
Series CY1S
28 ページ
-
SeriesCQ2/CQS/CQ
4 ページ
-
In-line Air Filter
12 ページ
-
5 Port Solenoid Valve
60 ページ
-
Series CQ2/CQS
2 ページ
-
AS series
2 ページ
-
corporate guide
13 ページ
-
ZP
69 ページ
-
ZFA
14 ページ
-
ZA
13 ページ
-
MHF
32 ページ
-
MHZ
68 ページ
-
CRB
44 ページ
-
D
117 ページ
-
RB
23 ページ
-
CEP
44 ページ
-
RSK
30 ページ
-
CLK
51 ページ
-
MK
20 ページ
-
GLJ
65 ページ
-
MGJ
7 ページ
-
Mx
36 ページ
-
MXH
18 ページ
-
My3
56 ページ
-
my1b
20 ページ
-
CC
15 ページ
-
J
14 ページ
-
CQ2
51 ページ
-
standard cylinder
84 ページ
-
VFN
6 ページ
-
SY3000
246 ページ
-
SJ3A6
18 ページ
-
1301/IW
14 ページ
-
CHQ/CHDQ
19 ページ
-
AC
95 ページ
-
HAW
4 ページ
-
HAA
3 ページ
-
ZB
24 ページ
-
CRB2
35 ページ
-
CJ1
5 ページ
-
SYJ
62 ページ
-
SJ
78 ページ
カタログアーカイブ
-
SYJ300/500/700 Series
62 ページ
-
Vacuum Unit ZK2 Series
60 ページ