カタログ >
SATEC >
Pole‐Top MV Sensors

Pole‐Top MV Sensors
1 / 2ページ

カタログの抜粋

For Smart Grid Deployment SATEC PM17x series can be supplied with Line Post Sensors for replacing of existing pole isolators with voltage and current sensors for MV grids of 15kV, 25kV or 35kV. The MV Sensors are designed for Distribution Automation to provide: Compact, economical power‐line sensing No line cutting Not for dead‐end use Linear outputs up to fault levels Accurate performance Non‐hazardous voltage on output Completely sealed against moisture Advantages of Sensor Monitoring Precise Real‐Time measurements Provides DNP3.0 protocol GPRS Communication Local display Memory (redundancy) Waveform / PQ features Phasors & phase rotation Directional Harmonics Neutral currents Complete Total Cabinet Package Expandability Help Manage Line losses Capacitor controls Voltage regulation Outage detection Load balance Harmonics Fault location Power theft Speciiffiicattiions arre subjjectt tto change wiitthoutt nottiice..

カタログの1ページ目を開く

Sensor Specifications ELECTRICAL RATINGS Low Freq. Dry Flashover Using SATEC PM17x Class 0.5s Calibration MECHANICAL Insulation Class Cantilever Strength (Ultimate) Low Freq. Wet Flashover Sensor Native Accuracy OPERATING TEMPERATURE CURRENT SIGNAL OUTPUT The pole‐top sensor is molded from polysil, a high dielectric strength, anti‐tracking polymer concrete developed under epri contract

カタログの2ページ目を開く