カタログ >
Ophir Optronics >
ModeCheck ®

ModeCheck ®
1 / 3ページ

カタログの抜粋

3.8 A New Method to Assure the Performance of High Power CO2 Lasers ■ Beam Profiler for collimated C02,10.6um wavelength, beam width up to 30mm ■ Quality Cutting, Marking, Drilling & Ablating Reguire More Than Consistent Laser Power ■ Instantaneously "see" and measure the beam - reduce set-up time between jobs ■ Real-time "mode burns" - eliminate hazardous acrylic vapors Optimize laser efficiency - reduce cost per part ■ Predict laser preventative maintenance - increase manufacturing efficiency ModeCheck is designed for the industrial parts manufacturer to reduce the time it takes to change over between different jobs. The user can guickly place the ModeCheck in front of the laser and see and measure, in real-time, the laser beam profile to confirm optimal laser performance. In addition, and when used periodically, the user can compare measurement changes from the same set-up and make necessary laser adjustments, keeping the laser output constant for the same job from day-to-day. Over time the user will be able to see and measure laser degradation to predict and advance schedule down- time needed for periodic maintenance. ModeCheck eliminates operator exposure to acrylic mode burn hazards while improving product guality and manufacturing efficiency. In addition to both 2D and 3D graphical image display and save, the following measurements are made from each image: ■ Bea m Width sand Dia meters ■ Beam Position Stability ■ Power Density Peak ■ Beam Centroid Location ■ Elliptical Analysis with Major Axis Orientation It's just this easy. 1. Remove Pocusing optic or attach the optional MLA 2. Locate the beam center with pointing beam or similar device 3. Place ModeCheck in beam center 5. Instantly see, measure and electronically store the beam " _ ! Pho""" For latest updates please visit our website: www.ophiropt.com/photonics aaw?PMm=. 01.01.2016

カタログの1ページ目を開く

Optional Accessories One must manage the pass-through laser beam by collecting the beam using either a power meter or beam dump. We recommend using a power meter as the additional measurement information will assist in managing laser optimization. Note that any beam dump or power meter large enough to handle 5-1 OkW will reguire water cooling. There are holes on the bottom of ModeCheck for mounting the Power Meter Head or Beam Dump. A ruggedized storage/carrying case is highly recommended for safe and efficient handling. The ModeCheck Lens Adapter (MLA) is an option that will enable a...

カタログの2ページ目を開く

3.8.1.1 Specifications Model Specifications Model Laser Input Power Input Clear Aperture Laser Type Beam Width Pick-off Percent Damage Threshold Camera 100-5000 Watts (or more depending on Beam size) 50mm (~2”) CW, Pulsed >100 KHz 5mm - 30mm 0.5%, 1%, 2%, 4%, 10% sampling wands; user replaceable 27 - 36 W/cm2; See graph 1/3” format CMOS, 480x480, 6µm pixel, 8bit, CS-mount, USB2 12mm C-mount Built in Fan (water required for the optional beam dump or optional power meter sensor) LED array ModeCheck Input: 100-240 Vac, 50-60Hz, 1.5A Output: 12Vdc, 5.0A, w/power jack, UL listed and CE compliant...

カタログの3ページ目を開く