カタログ >
OMEGA/オメガ >
AHPF Series

AHPF Series
1 / 1ページ

カタログの抜粋

LOW FLOW AIR PROCESS AND LIQUID CIRCULATION HEATERS For In-Line Air, Gas and Liquid Heating U 316 Stainless Steel Construction U Air/Gas Flow up to 15 CFM U Air/Gas Outlet Temperatures up to 430°C (800°F) U Pressures up to 100 psi U 50 Watts/Square Inch** The AHPF Series heaters are used to heat low flows of air, gas, water, or aqueous solutions. Applications include those where clean air is necessary, as in laboratories and environmental testing areas. The stream of air is heated by passing over an enclosed heated surface rather than directly over resistance elements. This method assures that no foreign matter will enter the stream of flow. The AHPF Series is also used as a miniature circulation heater for small volume of liquids as in photographic developer solution, chemicals, dyes, and inks. For heating liquids, contact engineering. The Thermocouple “T” fitting AHPF-NPT12 can be used with the subminiature thermocouple probes and with the SSLK series stainless steel compression fittings (see omega.com) and with stainless steel compression fittings (Model SSLK-18-14) to monitor or control temperature at the outlet of the AHPF series heaters. SPECIFICATIONS Cross Sectional Area: 0.152 square inches Pressure Rating: Up to 100 psig Wattage Tolerance: +5, -10% or better at the voltage specified Outside Diameter: 32 mm (1 %") Inlet: Male 38" NPT Outlet: J4" NPT 'h' NPT Female Pipe Thread Model Number To Order Visit omega.com/ahpf_heater for Pricing and Details * Indicates watts per inch of heated length. Use the table above to determine minimum required flow rates. ** These air heaters can be operated on either 120 or 240V. Specifications are shown for either 120 or240V operation. Ordering Example: AHPF-101, 120V, 1000 W low flow air process and liquid circulation heater. or Shop Online at omega.com SM

カタログの1ページ目を開く