Thermoreflectance by Pulsed Light Heating NanoTR/PicoTR
1 / 9ページ

Thermoreflectance by Pulsed Light Heating NanoTR/PicoTR Thermophysical Analysis of Thin Films: Thermal Diffusivity, Thermal Effusivity, Thermal Conductivity and Interfacial Thermal Resistance Analyzing & Testing

THERMOREFLECTANCE The Method for the Determination of the Thermal Diffusivity in the Nanometer Thickess Range With the significant progress in the design of electronic devices and the associated need for efficient thermal management, accurate thermal diffusivity / thermal conductivity measurements in the nanometer range are crucial more than ever. Materials with such thicknesses are used in phase-change memories (PCM), thermoelectric thin films, light emitting diodes (LED), interlayer dielectrics, and transparent conductive films (FPD), etc. The National Institute of Advanced Industrial...

WHY MEASURING THIN FILMS? Thermophysical Properties of Thin Films are Different from that of Bulk Materials The plot below indicates the dependency of thermal diffusivity on the grain size. At decreasing grain size (film thickness), the thermal diffusivity values decrease, especially close to the mean free path of electrons (~1.5×10-5 m2/s at 15 nm). The thermal diffusivity of bulk material is ~5.4×10-5 m2/s and therefore three to four times higher. For this reason, it is essential to determine the thermal diffusivity of thin films as well. The thicknesses of nanometer-thin films are often...

Thermoreflectance Methods TIME DOMAIN THERMOREFLECTANCE – REAR HEATING/FRONT DETECTION (RF) Determination of Thermal Diffusivity and Interfacial Thermal Resistance The fact that the thermophysical properties of thin layers and films differ considerably from those of the corresponding bulk material requires a technique which overcomes the limitations of the classical laser flash method (LFA). This so-called ultrafast laser flash technique is also known as rear heating/front detection (RF) mode. The measurement setup is similar to the conventional LFA: detector and laser are on opposite sides...

Temperature History Curve of TiN Thin Films Consisting of Different Thicknesses 200 nm Amplitude (normalized) Amplitude (normalized) Amplitude (normalized) Amplitude (normalized) This plot shows temperature nm films, 200-, excursions of TiN200thin 400- and 600-nm thick, measured in the RF configuration. The front surface of the thin films was heated by laser pulses, and the resultant temperature rise of the ∙10-6 m /s back surface was monitored. Temperature History Curve of an OEL Thin Film Between Two Metal Layers Al Al NanoTR is in accordance with JIS R 1689, JIS R 1690, and SI traceable...

Applications Temperature History Curve of a ZnO Thin Film on a Transparent Substrate Due to its wide band gap and large exciton-binding energy, ZnO has been attractive for applications in optoelectronic devices, ultra-violet emitters, sensors, etc. Thermoreflectance signal PicoTR measurements on ZnO samples in FF configuration (see picture below): 100 nm Mo on ZnO 420 nm (red); 100 nm Mo on ZnO 130 nm (light green); 100 nm Mo on ZrO2 (purple); 100 nm Mo on quartz (blue) As expected, this example demonstrates that the cooling rate of the surface temperature is influenced by the thermal...

Technical Specifications Temperature History Curve of SiO2 Thin Films Mo thin layers were deposited on both sides of the SiO2 thin films, and triple layer analysis was applied. For each of the curves obtained with the different layers of SiO2, the areal heat diffusion time* was calculated and plotted as α function of thickness. Based on these results, the thermal resistance of the SiO2/Mo interface and the thermal diffusivity (α) of the SiO2 layer can be calculated to 8.8×10-7 m2/s using the formula: Thermorelectance signal/a.u. Thermorelectance signal/a.u. Thermorelectance signal/a.u. The...

OBTAINING RESULTS IN SECONDS IN-SITU DISPLAY AND ANALYZING Rear heating/front detection (RF mode) The thermal diffusivity is measured cross sectionally using RF configuration. The obtained temperature rise curves fit with the theoretical equation to determine heat diffusion times (Mirror image method). The state-of-the-art measurement/analysis software of NanoTR/PicoTR has an easy-to-handle user interface which allows for precise determination of the thermal properties of thin films. Focusing of the laser beam can be adjusted by the software and a CCD picture can be obtained. NanoTR/PicoTR...

The NETZSCH Group is an owner-managed, international technology company with headquarters in Germany. The Business Units Analyzing & Testing, Grinding & Dispersing and Pumps & Systems represent customized solutions at the highest level. A worldwide sales and service network ensure customer proximity and competent service. Our performance standards are high. We promise our customers Proven Excellence – exceptional performance in everything we do, proven time and again since 1873. NETZSCH-Gerätebau GmbH Wittelsbacherstraße 42 95100 Selb, Germany Tel.: +49 9287 881-0 Fax: +49 9287 881-505...