UPA
1 / 118ページ

{{requestButtons}}

カタログの抜粋

UPA - 1

Type Series Booklet 3400.5/6--10 50 Hz Submersible Borehole Pumps Applications -- Drinking and service water supply -- Irrigation and spray irrigation -- Lowering and maintaining ground water levels -- Pressure boosting -- Fountains -- Mining, offshore, tank farms -- Building services systems -- VDS sprinkler systems Operating Data Capacity Q up to 840 m3/h (233 l/s) Head H up to 480 m Temperature of fluid handled t up to +50 °C Speed n 2900 rpm Supply voltage U up to 10,000 V Design Single-- or multistage centrifugal pumps in pump shroud or in ring--section design. Radial or mixed flow hydraulic systems; reduced impeller diameters also available in some cases. The stage casings of radial pumps are connected by metal straps, those of mixed flow pumps by stud bolts. Suction casing fitted between pump and motor. Suction casing equipped with strainer to protect the pump from coarse particles in the fluid. Pumps with check valve or connection branch on option. Available with threaded or flanged end on option. Particularly suitable for vertical installation in narrowdeep wells. Pump Designation (Example) UPA 200 B -- 80 / 5 b Type series Minimum well diameter (mm) (for ex.: 200 mm = 8 inches) Design status Capacity Qopt (m3/h) -- (4 up to 10 inches) 1) (l/s) -- (12 inches and above) Number of stages Reduced impeller diameters 1) UPA 200 -11 + 14: Q in l/s. Motor Designation (Example) UMA 250 D 110 / 2 1 Type series Well diameter (mm) (for ex. 250 mm = 10 inches) Design status Rated power PN (kW) Number of poles Winding insulation Certification Quality management certified to ISO 9001 Submersible Borehole Pumps S 100D, UPA 100C, UPA 150C, UPA 200, UPA 200B, UPA 250C, UPA 300, UPA 350, BSX -- BSF, UPZ Available automation products: • Hyamaster (UPA 200 -- UPA 350) • hyatronic (UPA 200 -- UPA 350) • switch gear (S 100D -- UPA 350) Complete Range The complete submersible borehole pump range comprises pump models for flow rates up to Q = 2500 m3/h (695 l/s) and heads up to H = 1500 m. The submersiblemotor range covers sizes for power ratings up to P = 3500 kW and voltages up to U = 10,000 V for 50 and 60 Hz. In addition, a special range is available which features submersible motors with a higher number of poles.

カタログの1ページ目を開く
UPA - 2

50 Hz Submersible Borehole Pumps 2 Contents Page The Submersible Borehole Pump Range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Operation with Soft Starters . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Operation with Frequency Inverter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Typical Installation Positions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Submersible Borehole Pump Selection for Deep Wells . . . ....

カタログの2ページ目を開く
UPA - 3

50 Hz Submersible Borehole Pumps 3 What can you expect from the “Submersible Borehole Pumps Booklet”? The information provided can help you make a -- quick -- first rough selection -- on your own to find a suitable KSB submersible borehole pump for your application.We have kept the volume of the catalogue down to what we think is the absolute minimum. For the 4 to 14 inch range, you will find the following information on the pump selected: -- pump series, size and number of stages, -- motor series, size, power, amperage, and allowable temperature, -- starting method, supply voltage and type...

カタログの3ページ目を開く
UPA - 4

50 Hz Submersible Borehole Pumps 4 The Submersible Borehole Pump Range " S 100D (4 inch) p. 11 -- 22 " UPA 100C (4 inch) p. 23 -- 32 " UPA 150C (6 inch) p. 33 -- 56 UPA 200 " (8/10 inch) p. 57 -- 65 " UPA 200B (8/10 inch) p. 65 -- 69 UPV 150S (6 inch) on request " UPZ BSX - BSF ( 16 inch) p. 91 -- 98 on request " UPA 300, 350 (12/14 inch) p. 77 -- 90 " UPA 250C (8/10 inch) p. 70 -- 76 " UPV 200 (8 inch) on request

カタログの4ページ目を開く
UPA - 5

Voltage [%] Time [s] Run--up Operation Run--down 4s 4s 120 100 80 60 40 20 0 50 Hz Submersible Borehole Pumps 5 Operation of KSB submersible motor pumps with soft starters Soft starter electronically reduce the incoming line voltage and, hence, the initial starting torque and starting current of electric motors. During run--up they gently ramp up the applied voltage to the motor. In the case of submersible motors, the extremely slim design and consequential small moments of inertia result in special characteristics, which differ strongly from normal asynchronous motors. Effects on...

カタログの5ページ目を開く
UPA - 6

50 Hz Submersible Borehole Pumps 6 Pump Operation with Frequency Inverter In principle, the motors of submersible borehole pumps can also be run on a frequency inverter. As submersible motors differ from conventional standardized motors in terms of bearings, moment of inertia, insulation, temperature increase, loss distribution and heat distribution, the following parameters must be observed: -- Maximum allowable acceleration time (start ramp) -- Maximum allowable deceleration time (stop ramp) -- Minimum frequency -- Maximum operating frequency -- Maximum permissible voltage increase...

カタログの6ページ目を開く
UPA - 7

50 Hz Submersible Borehole Pumps 7 Typical Installation Positions a) Vertical Installation (deep well, pump sump, etc.) CAUTION: The construction of the well head must meet the relevant regulations of the competent authorities! The unitmust never be installed with its suction strainer exactly at the level of the well screen / filter! Before installing the unit in narrow deep wells we recommend to check narrow boreholes for dimensional accuracy over their entire length, e.g. by inserting a pipe of the length and biggest outside diameter of the pump unit. Sharp bends or bottlenecks can make...

カタログの7ページ目を開く
UPA - 8

50 Hz Submersible Borehole Pumps 8 Submersible Borehole Pump Selection for Deep Wells Pump Selection The following data are required for a first rough selection of a submersible borehole pump: -- Capacity Q in m3/h (l/s) -- Pressure at well head HA in m -- Well diameter in inches or mm -- Temperature of fluid handled tA in °C -- Pump head HP in m While Q, HA, Dand tA are usually specified by the customer, the head HP to be developed by the pump needs to be calculated. There are two typical applications to be considered (see the drawing on the right): 1. Pumping into an open overhead tank HP...

カタログの8ページ目を開く

KSBのすべてのカタログと技術パンフレット

  1. RPH

    2 ページ

  2. HERA-BD

    2 ページ

  3. SISTO-10

    24 ページ

  4. BOA-CVE H

    2 ページ

  5. UPA

    104 ページ

  6. HPK-L

    2 ページ

  7. KWP

    2 ページ

  8. Etachrom L

    2 ページ

  9. Amarex N

    2 ページ

  10. Etaline-R

    2 ページ

  11. BOA-R

    16 ページ

  12. TRIODIS 150

    2 ページ

  13. Cervomatic EDP.2

    10 ページ

  14. Etabloc SYT

    2 ページ

  15. Type Series Booklet

    22 ページ

  16. Type Series Booklet

    14 ページ

  17. ACTELEC 31 to 1600

    18 ページ

  18. Amaclean

    12 ページ

  19. Amacan S

    2 ページ

  20. Amacan P

    2 ページ

  21. Amacan K

    2 ページ

  22. Ama-Drainer-Box

    2 ページ

  23. Ama-Drainer 80/100

    20 ページ

  24. LevelControl Basic 2

    36 ページ

  25. Amar-Drainer 4../5

    16 ページ

  26. UGS

    12 ページ

  27. ACTELEC EZ SQ

    20 ページ

  28. ACTELEC SQ AUMA

    14 ページ

  29. ACTELEC 31 to 800

    12 ページ

  30. ACTAIR 1.5 to 1600

    20 ページ

  31. PumpMeter

    12 ページ

  32. KSB Sonolyzer

    5 ページ

  33. Etachrom L

    40 ページ

  34. Etanorm/Etabloc

    70 ページ

  35. AKG-A/AKGS-A

    12 ページ

  36. Amamix

    2 ページ

  37. Amaprop

    2 ページ

  38. HQ

    2 ページ

  39. BOAX-CBV13

    3 ページ

  40. Ama-Porter F, S

    2 ページ

  41. Magnochem

    2 ページ

  42. Secochem Ex

    2 ページ

  43. Hya-Solo D

    44 ページ

  44. HGB, HGC

    4 ページ

  45. GZ 9

    2 ページ

  46. Etaseco

    2 ページ

  47. Etanorm

    2 ページ

  48. Etaline

    2 ページ

  49. CTN / -H

    2 ページ

  50. CINCP / CINCN

    2 ページ

  51. CHTC

    2 ページ

  52. Calio S

    2 ページ

  53. AMADS

    2 ページ

  54. Ama-Drainer Box

    2 ページ

  55. YNK

    2 ページ

  56. RHR/RVR

    2 ページ

  57. RHM

    2 ページ

  58. HGC

    2 ページ

  59. CHTD

    2 ページ

  60. Danais 150/300

    2 ページ

  61. RPHb

    2 ページ

  62. MegaCPK

    2 ページ

  63. RPH-V

    2 ページ

  64. RDLO

    2 ページ

  65. Multitec

    2 ページ

  66. INVCP

    2 ページ

  67. SuPremE

    2 ページ

  68. The Range of Valves

    74 ページ

  69. Pumps and Automation

    66 ページ

カタログアーカイブ

  1. Handle S series

    8 ページ

  2. MR 25 to 1600

    16 ページ

  3. MN

    4 ページ

  4. MA

    4 ページ

  5. ENNACTO 200 to 12500

    20 ページ

  6. DYNACTO 12 to 400

    16 ページ

  7. ACTO 25 to 12500

    16 ページ

  8. ACTAIR 1,5 to 1600

    20 ページ

  9. MAT-P

    4 ページ

  10. BOA-CVE

    16 ページ

  11. SICCA GTF 800-2500

    8 ページ

  12. VTS

    4 ページ

  13. BOA-RVK

    4 ページ

  14. BOA-Control IMS

    8 ページ

  15. HERA BD

    6 ページ

  16. ZJSVA/ ZXSVA

    6 ページ

  17. BOACHEM

    4 ページ

  18. BOA-H

    2 ページ

  19. BOA-SuperCompact

    8 ページ

  20. LSA-S

    4 ページ

  21. HGM

    4 ページ

  22. Trialine

    12 ページ

  23. Trialine Z

    12 ページ

  24. Riovar/Riovar Z

    16 ページ

  25. Rio-Eco/Z

    24 ページ

  26. Riotherm

    4 ページ

  27. Rio/Rio Z

    32 ページ

  28. PHZ

    15 ページ

  29. Ixo

    4 ページ

  30. CTN

    4 ページ

  31. Ama-Porter

    24 ページ

  32. Ama-Porter ICS

    16 ページ

  33. SPY-2-Page Product

    2 ページ

  34. Amaprop

    4 ページ

  35. Omega / Omega V

    56 ページ