Tool Selection
1 / 3ページ

カタログの抜粋

Tooling Selection Guide Cutters, Inserts & Cutting Parameters This new Milling Selection Guide leads you easily to the tool selection and to the corresponding user information. 6 steps enable you to select the suitable cutter, insert geometry and grade in relation with recommended parameters for Feed and Speeds. 1 Body Fixation Family Range Diameter Range Ramping angles High Feed Shell Mills Facing pitch Technical Information Diameter Range Select a Cutter Body Diameter Go to the referred Family page with the entire product range and technical information Body Fixation Available diameters, body fixation and type of inserts can also be found. (7792VX family selected) Dimensions (inch) Insert Shape and Size Slotting Shoulder Contour Milling Family Range Go to the Tool guide on page 10 - 17. Select the milling family according to the application. Modular Heads 6 Step Tool Selection Helical hole (min - max) ap max Helical / Linear ae max plunging High Feed Milling Cutter Helical Interpolation Helical Interpolation with Bore Hole Item Description Slotting / Shoulder Dimensions (inch) Spiral / Circular Weldon Shank 7792VXD09 Shell Mill Fixation - Coarse, Medium and Fine Pitch 029476 029477 030431 030432 030433 Item Description Dimensions (inch) Spares Screw Tightening in. lbs. Note: For cylindrical shank extensions in high density alloy with through coolant refer to page 86. Shell Mill Fixation 7792VXD09 Technical Information (inch) Product Dimensions Ramping Angle A° B° Item Description Modular Head Facing Pitch Helical Interpolation Facing Pitch Ramp angle A uses one outside cutting edge only. Ramp angle B uses two cutting edges (one outside and one inside edge). A A = max ramp angle utilizing full face contact B = max ramp angle utilizing full contact + internal corner radius

カタログの1ページ目を開く

Select the Insert according to the application and material to be machined. ^i> Application Section • Facing, Semi-Finishing and Finishing Or • Facing, Slotting and Plunging (7792VX series) ^2| Material to be machined For each insert, a colored symbol will advise you about the performance, as well as the materials which can be machined. The color of the symbol corresponds to the ISO Material designation. Symbol explanation: ^ 1st choice: Excellent performance ■ 2nd choice: Good performance • 3rd choice: Alternative option Milling Inserts & Recommended Feeds Example: Material: Alloyed...

カタログの2ページ目を開く

Tooling Selection Guide Cutters, Inserts & Cutting Parameters 6 Step Tool Selection (continued) Speed vc (SFM) Wear Resistance Coolant Recommendation Select the recommended Cutting Speed (vc) and Coolant recommendations according to the material to be machined. France: AFNOR Austenitic + Ferritic 300 series Spheroidal-Ductile GGG-FGS Stainless Steel Grey GG-Ft Cast Iron Aluminum & Alloys Cobalt Based Nickel Based Titanium Based High Temperature Alloys Hard Materials Aluminum + Silicon > 16% Si 92 HBN Iron Based Uncoated Micrograin Alloyed Steel Material specifications can be found in the...

カタログの3ページ目を開く

Tool Selection 1 / 3ページ

カタログの抜粋

Kennametal/ケナメタルのすべてのカタログと技術パンフレット

Tool Selection
1 / 3ページ