ROLLERS SERIES 1100
1 / 3ページ

カタログの抜粋

ROLLERS SERIES 1100 Gravity conveyor roller ROLLERS SERIES 1100 Gravity conveyor rollerApplication area High corrosion resistance Internal conveyor systems, The rollers consist of stainless material. Upon request, it is also possible to use stainless steel balls. particularly suited for cost-efficient implementation of gravity or push Resistant to contamination conveyors. Can also be used in the The smooth surfaces protect against dirt accumulation. food processing sector. The grease used in the bearings is FDA- Lateral loading compliant. The tube ends are rounded, thereby allowing materials to be easily moved on from the side. Robust construction For axial fixation of the bearing housing, the bearing assemblies for PVC tubes starting at a diameter of 30 mm are secured with an internal press-in edge in addition to the press fit. Planning basics Rollers | Conveying elements | RollerDrive | Controls | Accessories General technical information

カタログの1ページ目を開く

ROLLERS SERIES 1100 Gravity conveyor roller iQQ ii iQS ii ROLLERS SERIES 1100 Gravity conveyor roller © Load capacities of series H00 with screw-connected installation The load capacity table refers to a temperature range of +5 to +40 °C. Valid for the following shaft designs: female thread or male thread. Bearing: guided balls, no precision ball bearing. Load capacities of series H00 with loose installation The load capacity table refers to a temperature range of +5 to +40 °C. Valid for the following shaft designs: spring-loaded shaft, fixed shaft or flatted shaft. Bearing: guided balls,...

カタログの2ページ目を開く

ROLLERS SERIES 1100 Gravity conveyor roller ROLLERS SERIES 1100 Gravity conveyor roller 4x Dimensions Spring-loaded shaft The dimensions of the conveyor roller depend on the shaft version. A sufficient axial play is already taken into account, so that only the actual lane width between side profiles is required for ordering. Ordering dimensions for tube sleeves, e.g. PVC sleeves, see page 31. RL = Reference length / ordering length EL = Installation length, inside diameter between side profiles AGL = Total length of shaft U = Usable tube length: Length without bearing housing and for...

カタログの3ページ目を開く