カタログ >
HepcoMotion >
Incorporating DLS and GV3 into MCS Framework Systems

Incorporating DLS and GV3 into MCS Framework Systems
1 / 4ページ

カタログの抜粋

Incorporating DLS and GV3 into MCS Framework Systems - 1

Hepco SBS35 slide beam

Incorporating DLS and GV3 into MCS Framework Systems - 2

Hepco MCS profile 80 x 80 Hepco MCS profile 90 x 90L All brackets have holes and slots with clearance for M6 screws, unless otherwise stated. (Screws specified but not supplied: refer to table.)

カタログの2ページ目を開く

Incorporating DLS and GV3 into MCS Framework Systems - 3

Compatibility Table JOINT (MCS) (DLS/SB) (MCS) (DLS/SB) MCS PROFILE 1-242DFC-3-S These joints are possible. ✔● The joint is possible for only one orientation of the MCS section ✔■ The joint is possible but the bracket is wider than the MCS section.

カタログの3ページ目を開く

Incorporating DLS and GV3 into MCS Framework Systems - 4

Joining DLS units together to make multi-axis systems The lightweight DLS profile may be preferable for high inertia Y axis applications. Please refer to Hepco DLS and GV3 catalogues. X and Y axis DLS units may be coupled together in any combination of size. Fixing holes must be drilled and tapped accordingly. For Z axis requirements please refer to Cantilever axis in DLS catalogue. Clamp method For attaching Y axis in orientation as shown. Please refer to DLS catalogue for details of the DFC-3-L and DFC-4-L M6x20 screws DFC-3-L fixing clamp Y M6 customer mounting holes T-nut method For...

カタログの4ページ目を開く